User manual ROLAND V-SYNTH GT annexe 1

[. . . ] Error Messages Copyright © 2007 ROLAND CORPORATION All rights reserved. No part of this publication may be reproduced in any form without the written permission of ROLAND CORPORATION If an incorrect operation is performed, or if processing could not be performed as you specified, an error message will appear. [. . . ] Use the device that created the file to convert the data into an 8 bit or 16 bit wave. Alternatively, move the entire folder to a shallower level of the hierarchy. The "path" indicates the hierarchical level at which the file is located. Path Name Too Long! A patch or sample used by the project or patch was not found on disk. This file uses a type of compression that the V-Synth GT is unable to read. Since the amount of memory you can use for sampling has become full, the operation was halted. Unknown System Error! Cannot find the project specified as the current project. This file contains waves for three or more channels, and cannot be loaded into the V-Synth GT. An internal memory or USB memory error of unknown causes has occurred. Due to the capacity shortage of the USB memory, it couldn't write. The operation you attempted to execute does not support this USB memory. USB Memory Not Ready!You Cannot Use This Device! V-SYNTH/GT LEAFLET * 4 0 7 8 1 3 4 5 0 1 * 40781345 1PD Message Boxes Message boxes are displayed briefly, and then disappear automatically. Message Canceled! [. . . ] Check whether there is a problem with the MIDI cable connected to the V-Synth GT's MIDI IN, or whether the MIDI cable has been disconnected. Please Wait a Minute. Check whether there is a problem with the USB cable connected to the V-Synth GT's USB connector, or whether the USB cable has been disconnected. Writing. . . Data is being written. [. . . ]