User manual ROLAND MZ-2

[. . . ] Otherwise, you risk getting your hands or fingers pinched, or damaging the collar lock. The stand may fall over if the legs are not fully opened, causing the keyboard to fall. * Be sure to tighten the screws on both the left and right legs securely. Raise the vertical struts until they are positioned straight up, then spread them out to the left and right until they come to a stop. [. . . ] Raise the vertical struts until they are positioned straight up, then spread them out to the left and right until they come to a stop. * Spread the struts outward carefully so as not to allow your hands or fingers to be pinched. * Position the arms carefully so as not to allow your hands or fingers to be pinched. Pull the knobs out towards you and set the inner struts to the desired height. Check the height setting numbers marked on the inner struts to make sure that both the left and right legs are set to the same height. * Of the numbers for setting the strut height, use only the numbers from 1 through 12. Setting the height at 13 is not recommended, as this may make the stand unstable. * Take care not to let your hands or fingers get caught and pinched in the notches for the height setting numbers. You can adjust the degree to which the struts open by attaching or removing the angle adapters. * Attach the angle adapters on the inner sides of the strut hinges to prevent from losing them (refer to Fig. In the case of the symbol at left, it is used for general cautions, warnings, or alerts to danger. The symbol alerts the user to items that must never be carried out (are forbidden). The specific thing that must not be done is indicated by the design contained within the circle. In the case of the symbol at left, it means that the unit must never be disassembled. The specific thing that must be done is indicated by the design contained within the circle. In the case of the symbol at left, it means that the powercord plug must be unplugged from the outlet. Before using this unit, make sure to read the instructions below, and the Owner's Manual. (The only exception would be where this manual provides specific instructions which should be followed in order to put in place user-installable options; see p. Should you remove leg securing screws, angle adapters, and angle adapter screws, keep them in a safe place out of children's reach, so there is no chance of them being swallowed accidentally. Do not attempt to repair the unit, or replace parts within it (except when this manual provides specific instructions directing you to do so). [. . . ] (The only exception would be where this manual provides specific instructions which should be followed in order to put in place user-installable options; see p. Should you remove leg securing screws, angle adapters, and angle adapter screws, keep them in a safe place out of children's reach, so there is no chance of them being swallowed accidentally. Do not attempt to repair the unit, or replace parts within it (except when this manual provides specific instructions directing you to do so). In addition to the items listed under "USING THE UNIT SAFELY" on this page, please read and observe the following: Make sure you always have the unit placed so it is level and sure to remain stable. [. . . ]