User manual ROLAND MRP-500

[. . . ] Additionally, in order to feel assured that you have gained a good grasp of every feature provided by your new product, Owner's manual should be read in its entirety. The manual should be saved and kept on hand as a convenient reference. Thank you, and congratulations on your choice of the Roland V-Stand MRP-500. [. . . ] Thank you, and congratulations on your choice of the Roland V-Stand MRP-500. Wrap clamp, with hinge on playing side, around stand strut on notch number 1 or 2depending on desired tier height. The hinges are inscribed with markings; set the hinges so that the markings face inward. * * * Take care not to loosen the angle adjustment knob too much when loosening the knob. Differences in the angle of the left and right arms will make the keyboard unstable; be sure to set the arms to the same angle. Check to see that the stand is safe to use, confirming that the arms have the stoppers in front and in a lowered position and making sure that the stand will not tip over. L refers to the left side and R to the right when facing the stand (KS-V7). If using the KS-V7 with the MRP-500 attached, do not use the stand with a keyboard only resting on the MRP-500. Should you remove the knob bolts, springs and washers, keep them in a safe place out of children's reach, so there is no chance of them being swallowed accidentally. (The only exception would be where this manual provides specific instructions which should be followed in order to put in place user-installable options; see pp. In addition to the items listed under "USING THE UNIT SAFELY" on this page, please read and observe the following: Do not attempt to repair the product, or replace parts within it (except when this manual provides specific instructions directing you to do so). For everyday cleaning wipe the product with a soft, dry cloth or one that has been slightly dampened with water. To remove stubborn dirt, use a cloth impregnated with a mild, non-abrasive detergent. Afterwards, be sure to wipe the product thoroughly with a soft, dry cloth. Make sure you always have the product placed so it is level and sure to remain stable. Never use benzine, thinners, alcohol or solvents of any kind, to avoid the possibility of discoloration and/or deformation. [. . . ] Make sure you always have the product placed so it is level and sure to remain stable. Never use benzine, thinners, alcohol or solvents of any kind, to avoid the possibility of discoloration and/or deformation. â· Do not use with cables over items crowded around the rear. [. . . ]