User manual ROLAND ME-6B

[. . . ] The manual should be saved and kept on hand as a convenient reference. Main features Simple Operation--Works Like a Compact Effects Processor Each effect is controlled with a dedicated knob. Intuitive operation, similar to that of compact effects processors, lets you make changes to tones directly. Multi-Function Expression Pedal The ME-6B is equipped with an expression pedal that gives you control over six different specialized pedal effects. It can also be switched for use as a volume pedal. Powerful COSM Drive Sound Roland's original "COSM" modeling technology lets you perform with a wide variety of powerful distortion effects, from classic vintage sounds, to original distortion sounds. COSM (Composite Object Sound Modeling) Composite Object Sound Modeling (COSM) is Roland's innovative and powerful sound modeling technology. [. . . ] When using this as a limiter, turn the SUSTAIN knob to the left (counterclockwise). When switched OFF, the COMPRESSOR indicator goes out. White Set the polarity switch as shown below. PCS-31 Red TONE MODIFY COMPRESSOR On/Off On/Off LEVEL knob Adjusts the volume level when the Compressor is on. Use this in achieving a volume balance when switching the Compressor on and off. * When in Memory mode, the bank-switching function is enabled (p. 22). 10 Using the Effects OVERDRIVE/DISTORTION fig. 0130 OVERDRIVE/DISTORTION Indicator OD/DS pedal Each time you press the pedal, the effect switches through Overdrive/Distortion ON and OFF. When switched on, the OVERDRIVE/DISTORTION indicator and pedal indicator light up. DRIVE knob Adjusts the amount of distortion. Turning the knob to the right (clockwise) creates a stronger distortion and increases the volume. Turning this all the way to the TURBO range increases the effect even more. BOTTOM knob Pedal Indicator Adjusts the low frequency range. Turning the knob to the left (counterclockwise) cuts the low end more; the low frequencies are boosted as the knob is turned to the right. OD/DS Pedal TONE knob Adjusts the tone. Turning the knob to the left creates a milder sound; a sharper sound is produced as the knob is turned to the right. You can use the TYPE knob in combination with [VARIATION] to get 22 different types of distortion. LEVEL knob Adjusts the volume. Type List [VARIATION] Off [VARIATION] Lit Overdrive that gives a more natural sounding distortion. A lustrous crunch sound with an added element of CRUNCH amp distortion. Hold down the MOD pedal for at least two seconds to complete the tempo setting. The effect goes on, and instead of flashing, the pedal indicator will light. * If you move the RATE/KEY knob after finishing this setting, the rate corresponding to the knob position takes effect. 14 Using the Effects DELAY fig. 0170 DELAY Indicator 0-30 ms Delay sound of 0 to 30 ms delay time. 25-125 ms Delay sound of 25 to 125 ms delay time. 100-500 ms Delay sound of 100 to 500 ms delay time. 400-2000 ms Delay sound of 400 to 2000 ms delay time. ANALOG Pedal Indicator This gives a mild analog delay sound. The delay time can be set within the range of 100 ms to 500 ms. SLOW ECHO DELAY Pedal This produces an effect combining a volume-swell sound with delay. The delay time can be set within the range of 200 ms to 1000 ms. PAN This effect adds delayed sound to the direct sound, giving more body to the sound or creating special effects. A panned delay in which the repeated sounds come alternately from the left and right channels. * When using the ME-6B in mono, the panning delay is not effective, even when PAN is selected. DELAY pedal The Delay is switched on or off each time you press the pedal. * DELAY ON/OFF switches the Delay at the input to provide a more natural effect. For this reason, if the FEEDBACK is turned up when the Delay is turned off, the delay sound will remain briefly. SPACE PAN This is a panning delay that gives an even wider spatial effect than PAN. * When using the ME-6B in mono, or when using headphones, the panning delay is not effective, even when SPACE PAN is selected. TYPE knob Sets the type of the delay * When a setting other than HOLD is selected, you can use the DELAY pedal to input the tempo, and set the delay time synchronized to the performance tempo. REVERSE This produces an effect where the sound is played back in reverse. You can get two different effects, "direct sound + effect sound, " or "effect sound only, " depending on the position of the E. LEVEL knob. [. . . ] If you encounter problems such as being unable to switch the PEDAL MODE SW on or off or fully cut off the sound with the volume pedal, you can use the following procedure to readjust the pedal. When you operate the expression pedal, please be careful not to get your fingers pinched between the movable part and the panel. In households with small children, an adult should provide supervision until the child is capable of following all the rules essential for the safe operation of the unit. 1, 2 2 3, 4 1. * To cancel Factory Reset, first turn off the power, and then turn it on again. [. . . ]