User manual ROLAND MDS-6SL

[. . . ] * Regarding the way of mounting a Sound Module, Pads, or Cymbals, please refer to the Owner's Manual supplied with them. * Do not spread open the stand farther than 135 degrees as shown in the illustration. When the MDS-6SL was shipped from the factory, it was configured for a right-handed drummer. [. . . ] If you wish to make left-handed set up, contact the nearest Roland Service Center, or an authorized Roland distributor. Stand (MDS-6SL) * If the drum stand is to be used for extended periods in the same location, we recommend using a Roland drum mat (TDM-10/ TDM-20) to prevent discoloration of flooring by the rubber feet. * In the interest of product improvement, the specifications and/or appearance of this unit are subject to change without prior notice. Do not expose the unit to direct sunlight, place it near devices that radiate heat, leave it inside an enclosed vehicle, or otherwise subject it to temperature extremes. Used for instructions intended to alert the user to the risk of death or severe injury should the unit be used improperly. Used for instructions intended to alert the user to the risk of injury or material damage should the unit be used improperly. * Material damage refers other adverse effects respect to the home furnishings, as well animals or pets. Use a reasonable amount of care when using the hand knobs, pipes, and mounts. When you need repair service, call your nearest Roland Service Center or authorized Roland distributor in your country as shown below. To prevent accidents, never allow small children to play near the stand. Do not attempt to repair the unit, or replace parts within it (except when this manual provides specific instructions directing you to do so). Never use or store the unit in places that are: · , direct sunlight in an enclosed vehicle, near a heating duct, on top of heat-generating equipment); or are · Try to prevent cords and cables from becoming entangled. Also, all cords and cables should be placed so they are out of the reach of children. Make sure you always have the unit placed so it is level and sure to remain stable. [. . . ] Make sure you always have the unit placed so it is level and sure to remain stable. Keep any screws, washers, bolts, nuts, tuning bolts, springs, hand knobs you may remove and the included cable ties in a safe place out of children's reach, so there is no chance of them being swallowed accidentally. Make sure to firmly tighten all clamps and bolts after you have assembled the stand and attached a pad or unit to it. [. . . ]