User manual ROLAND HP-101E

[. . . ] No part of this publication may be reproduced in any form without the written permission of ROLAND CORPORATION. WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. WARNING - When using electric products, basic precautions should always be followed, including the following: 1. [. . . ] Performance Pressing the "C#" key as you hold down the [Reverb/Key Touch] button reduces the amount of reverb effect applied. Holding down the [Reverb/Key Touch] button and pressing the "D#" key increases the reverb effect. You can change the Depth of the Reverb Effect by pressing any "C#" or "D#" key. To restore the depth of the reverb effect at the time the power is turned on, hold down the [Reverb/Key Touch] button and press the "C#" and "D#" keys simultaneously. By using the "Transpose function, " you can transpose your performance without changing the notes you play. For example, even if the song is in a difficult key with numerous sharps (#) or flats (b), you can transpose it to a key that is easier for you to play. When accompanying a vocalist, you can easily transpose the pitch to a range that is comfortable for the singer, while still playing the notes as written (i. Hold down the [Reverb/Key Touch] button and press either the "A0, " "B0, " "C1, " or "D1" key. The key touch is set to "Medium" when the instrument is turned on. Key Pressed Settings Fortissimo (ff) can be produced by playing less strongly than usual, making the keyboard feel lighter. Fortissimo (ff) cannot be produced unless you play more strongly than usual, making the keyboard feel heavier. Sounds at a fixed volume, regardless of your keyboard playing strength. Hold down the [Metronome] and [Reverb/Key Touch] buttons, and press the key for the note you want to set as the tonic. keys for Setting the Transposition: C5­B5 The keyboard will be transposed. For example, if you want the E pitch to sound when you play the C key, hold down the [Metronome] and [Reverb/ Key Touch] buttons and press the E5 key. This setting returns to the original value (0) when you turn off the power. To cancel the transposition, hold down the [Metronome] and [Reverb/Key Touch] buttons and press the "C5" key (transposition 0). Simultaneously playing two tones when one key is pressed is called "Dual play. Holding down the [Tone] and [Metronome] buttons and pressing the "D#" key raises the Dual Tone volume. To restore the depth of the reverb effect at the time the power is turned on, hold down the [Tone] and [Metronome] buttons and press both the "C#" and "D#" keys simultaneously. You can change the Dual Balance by pressing any "C#" or "D#" key. Hold down the [Tone] button and press a key to which a tone is assigned to select the fundamental tone (p. [. . . ] In particular, this problem occurs more easily when the bass component is increased, and when the sound is played at higher volumes. ⷠPlace speakers so they are 10­15 cm from walls and other surfaces. When listening through headphones: Here, a different cause would be suspect. The volume level of the instrument connected to Input jacks is too low Could you be using a connection cable that contains a resistor? [. . . ]