Detailed instructions for use are in the User's Guide.
[. . . ] Drum Key Screwdriver Manual Set Set-up Guide Video Manual Owner's Manual Roland Sticker
Make sure the foot pipes are securely fastened to the stand. If not you risk to damage the stand or have stability problems.
6
Correct any instability
If the stand wobbles because the floor is not perfectly flat, use the adjusters (three locations indicated by ) to adjust the height. In particular, when using the HD-1 on carpet, adjust these so that they are in firm contact with the floor. Be careful not to pinch your fingers or hands when making these adjustments.
1. [. . . ] . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
011
· The unit and the AC adaptor should be located so their location or position does not interfere with their proper ventilation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
102c
· Do not connect this unit to same electrical outlet that is being used by an electrical appliance that is controlled by an inverter (such as a refrigerator, washing machine, microwave oven, or air conditioner), or that contains a motor. Depending on the way in which the electrical appliance is used, power supply noise may cause this unit to malfunction or may produce audible noise. If it is not practical to use a separate electrical outlet, connect a power supply noise filter between this unit and the electrical outlet.
302
· When setting up or storing the HD-1, be careful so the fingers used to grasp the stand don't get pinched. Also, take care that the stand does not become unbalanced and fall over or fall against you. · When moving the HD-1, check the following points first, then be sure to keep the system in the horizontal position while lifting and carrying it. Check that the knobs and screws that fasten the pads, arm pipes, and foot pipes have not become loose. Disconnect external devices.
· To avoid disturbing your neighbors, try to keep the unit's volume at reasonable levels. You may prefer to use headphones, so you do not need to be concerned about those around you (especially when it is late at night).
558d
· This instrument is designed to minimize the extraneous sounds produced when it's played. However, since sound vibrations can be transmitted through floors and walls to a greater degree than expected, take care not to allow these sounds to become a nuisance to neighbors, especially when performing at night and when using headphones.
559a
· The AC adaptor will begin to generate heat after long hours of consecutive use. This is normal, and is not a cause for concern.
307
· When you need to transport the unit, package it in the box (including padding) that it came in, if possible. Otherwise, you will need to use equivalent packaging materials.
562
· Always grasp only the plug on the AC adaptor cord when plugging into, or unplugging from, an outlet or this unit. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
103b
· Before connecting this unit to other devices, turn off the power to all units. This will help prevent malfunctions and/or damage to speakers or other devices.
Maintenance
401a
· Do not allow any objects (e. g. , flammable material, coins, pins); or liquids of any kind (water, soft drinks, etc. ) to penetrate the unit. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
012b
· Never use or store the unit in places that are: Subject to temperature extremes (e. g. , direct sunlight in an enclosed vehicle, near a heating duct, on top of heat-generating equipment); or are Damp (e. g. , baths, washrooms, on wet floors); or are Humid; or are Exposed to rain; or are Dusty; or are Subject to high levels of vibration. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
007
· Immediately turn the power off, remove the AC adaptor from the outlet, and request servicing by your retailer, the nearest Roland Service Center, or an authorized Roland distributor, as listed on the "Information" page when: The AC adaptor, the power-supply cord, or the plug has been damaged; or If smoke or unusual odor occurs Objects have fallen into, or liquid has been spilled onto the unit; or The unit has been exposed to rain (or otherwise has become wet); or The unit does not appear to operate normally or exhibits a marked change in performance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
013
· At regular intervals, you should unplug the AC adaptor and clean it by using a dry cloth to wipe all dust and other accumulations away from its prongs. Also, disconnect the power plug from the power outlet whenever the unit is to remain unused for an extended period of time. Any accumulation of dust between the power plug and the power outlet can result in poor insulation and lead to fire. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
104
Placement
351
· Using the unit near power amplifiers (or other equipment containing large power transformers) may induce hum. To alleviate the problem, change the orientation of this unit; or move it farther away from the source of interference.
352a
· For everyday cleaning wipe the unit with a soft, dry cloth or one that has been slightly dampened with water. To remove stubborn dirt, use a cloth impregnated with a mild, non-abrasive detergent. [. . . ] However, in certain cases (such as when circuitry related to memory itself is out of order), we regret that it may not be possible to restore the data, and Roland assumes no liability concerning such loss of data.
Additional Precautions
551
· Before using the unit in a foreign country, consult with your retailer, the nearest Roland Service Center, or an authorized Roland distributor, as listed on the "Information" page. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
· Small parts such as the following should be kept out of the reach of small children so that they are not swallowed accidentally. Included items · Sound module attachment screws · Foot pipe attachment screws · Cymbal knobs · Cymbal felts · Cable ties Detachable items · Arm pipe attachment washers, hex nuts, and knobs · Pad attachment screws · Cymbal attachment rods and arm pipe attachment screws, hex nuts, and rubber bushings · Snare tuning bolts · Cable hooks · Adjusters . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
· Depending on the material and temperature of the surface on which you place the unit, its rubber feet may discolor or mar the surface. You can place a piece of felt or cloth under the rubber feet to prevent this from happening. [. . . ]