User manual ROLAND ADA-8024

[. . . ] The manual should be saved and kept on hand as a convenient reference. fig. 0(frontpanel) All product names mentioned in this document are trademarks or registered trademarks of their respective owners. No part of this publication may be reproduced in any form without the written permission of ROLAND CORPORATION. Roland Web site: http://www. roland. co. jp/ CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN ATTENTION: RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. [. . . ] If you wish to remotely control the ADA-8024 from a device connected via the R-BUS connector, make the MANUAL indicator go dark. 6 CLOCK SOURCE Button Selects the source of the sampling clock. Turn down the volume on all devices connected to the R-BUS (RMDB2) connector, RCA output jacks, and XLR output connectors (on the rear panel) before operating this button. R-BUS (RMDB2): The ADA-8024 will operate according to the sampling clock of the device (e. g. , digital mixer or digital recorder) connected to the rear panel R-BUS connector. When a clock signal is input from the R-BUS connector, the R-BUS indicator will light, and the SAMPLING FREQ indicator for that sampling frequency will light. If no clock is being input from the R-BUS connector, the R-BUS indicator will blink. If you have selected "RBUS (RMDB2)" as the sampling clock of the ADA-8024, you must set the master clock of the connected device to be other than the R-BUS to which that ADA-8024 is connected. WORD CLOCK: The ADA-8024 will operate according to the word clock signal that is connected to the rear panel WORD CLOCK connector. When a clock is being input from the WORD CLOCK connector, the WORD CLOCK indicator will light, and the SAMPLING FREQ indicator for that frequency will light. If no clock is being input from the WORD CLOCK connector, the WORD CLOCK indicator will blink. If you have selected "WORD CLOCK" as the sampling clock of the ADA-8024, you must set the master clock of the connected device to be the R-BUS to which that ADA-8024 is connected. INTERNAL: Select this when you want the ADA-8024 to operate on its own internal clock. 5. Make sure that the volume of the audio devices have been turned down. Set the master clock (sampling clock) of the ADA-8024 and of the devices connected to the R-BUS connector of the ADA-8024. Raise the volume of the audio equipments. 12 Block Diagram fig. 5 R-BUS (RMDB2) 1/2 3/4 5/6 7/8 1/2 3/4 5/6 7/8 XLR/TRS INPUT 1 + 2 3 1 1 ­ PAD -20 dB SENS + ­ 1 2 3 XLR OUTPUT (+4 dBu) PEAK 2 + A/D D/A + ­ 1 2 2 3 INPUT 2 3 1 ­ PAD -20 dB SENS 1 2 PEAK RCA OUTPUT (-10 dBu) 3/4 5/6 7/8 3/4 5/6 7/8 R-BUS CLOCK BNC WORD CLOCK IN TERMINATOR ON OFF 96 kHz 48 kHz 75 INTERNAL CLOCK PLL 44. 1 kHz 32 kHz OUT R-BUS (RMDB2) Circuit Connection fig. 6 1 14 2 15 3 16 4 17 5 18 6 19 8 20 9 21 10 22 11 23 12 24 13 25 SHELL 13 25 12 24 11 23 10 22 9 21 8 20 6 19 5 18 4 17 3 16 2 15 1 14 SHELL 13 Concerning Copyright The law prohibits the unauthorized recording, public performance, broadcast, sale, or distribution etc. of a work (CD recording, video recording, broadcast, etc. ) whose copyright is owned by a third party. Roland will take no responsibility for any infringement of copyright that you may commit in using the ADA-8024. Disclaimer of liability Roland will take no responsibility for any "direct damages, " "consequential damages, " or "any other damages" which may result from your use of the ADA-8024. These damages may include but are not limited to the following events which can occur when using the ADA-8024. · Any loss of profit that may occur to you · Permanent loss of your music or data · Inability to continue using the ADA-8024 itself or a connected device About the License Agreement The ADA-8024 and its CD-R capability are designed to allow you to reproduce material to which you have copyright, or material which the copyright owner has granted you permission to copy. Accordingly, reproduction of music CDs or other copyrighted material without the permission of the copyright owner, other than for your own personal use and enjoyment (private use) constitutes copyright infringement, which may incur penalties. Consult a copyright specialist or special publications for more detailed information on obtaining such permission from copyright holders. 14 Troubleshooting If the ADA-8024 does not function correctly, please check the following points before you suspect a malfunction. If checking these points does not resolve the problem, please contact Roland, a nearby Roland service center, or your dealer. The CLOCK SOUCE R-BUS (RMDB2) indicator is blinking. No sampling clock is being input to the R-BUS connector of the ADA-8024. Make the correct master clock settings on the device connected to the R-BUS connector (p. [. . . ] S-131 30 Nacka SWEDEN TEL: (08) 702 0020 Shanghai Xingtong Acoustics Equipment CO. , Ltd. Rm. 1108, No. 2240 Pudong South Road Shanghai, CHINA TEL: (021) 6873 4123 HONG KONG Tom Lee Music Co. , Ltd. Service Division 22-32 Pun Shan Street, Tsuen Wan, New Territories, HONG KONG TEL: 2415 0911 CENTRAL/LATIN AMERICA ARGENTINA Instrumentos Musicales S. A. Florida 656 2nd Floor Office Number 206A Buenos Aires ARGENTINA, CP1005 TEL: (54-11) 4- 393-6057 DENMARK Roland Scandinavia A/S Nordhavnsvej 7, Postbox 880, DK-2100 Copenhagen DENMARK TEL: (039)16 6200 TURKEY Barkat muzik aletleri ithalat ve ihracat Ltd Sti Siraselviler cad. Guney is hani 8486/6, Taksim. TURKEY TEL: (0212) 2499324 SWITZERLAND Roland (Switzerland) AG Musitronic AG Gerberstrasse 5, Postfach, CH-4410 Liestal, SWITZERLAND TEL: (061) 921 1615 FRANCE Roland France SA 4, Rue Paul Henri SPAAK, Parc de l'Esplanade, F 77 462 St. Thibault, Lagny Cedex FRANCE TEL: 01 600 73 500 U. A. E. Zak Electronics & Musical Instruments Co. [. . . ]