User manual PYRAMID CDR38DX

[. . . ] Its super low internal resistance to reproduce all of the music making it to your system an you coming are playing your system very loud, there may not be enough energy operating at 70% of full capacity. When a big bass note hits, or you conditioner running, the factory charging system may already be vehicle's electrical system is unable to provide it. [. . . ] When a big bass note hits, or you conditioner running, the factory charging system may already be vehicle's electrical system is unable to provide it. with your car 's air SEE INSTALLATION DIAGRAM. + - Capacitors are most effective when there is a 18" (0. 5m) or less of wire between the cap and the amplifier(s). Make sure your as car audio system is properly fused. You should have a system fuse for all components, the fuse should be installed within 18 inches of the battery. Use another wire from the positive terminal to your amplifier(s) positive supply terminal. The ground wire from the amplifier(s) should be connected to the capacitor's negative terminal. You can use a voltage meter to check the voltage across your battery and cup . when the voltages are the same on both(cap and battery), the cap has been fully charged. The charging bulb actually eliminates the need for the volt meter, when the cap is fully charged (cap and battery have same voltage) the bulb will go either dim or fully out. the capacitor must bi discharged when the capacitor is removed form the system. place the same bulb which was used in charging across the terminals of the capacitor to eliminate the stored power. The capacitor will bi fully discharged within a few seconds noted by the bulb going out. It is now safe to store your a capacitor. 1 year (except in the event the vent is blown or leaking due to reversed polarity or the cap has stripped screws or terminals) MODEL CDR38DX CAP160DBL CAP300DBL CAP500DBL CAPACITANCE 1. 5Farad 1. 6Farad 3. 0Farad 5. 0Farad VOLTAGE 20~24V 16~20V 16~20V 16~20V DIMENSION Dia. [. . . ] place the same bulb which was used in charging across the terminals of the capacitor to eliminate the stored power. The capacitor will bi fully discharged within a few seconds noted by the bulb going out. [. . . ]