User manual PACKARD BELL IMEDIA PT.U03-PV.U03

[. . . ] Make sure that your computer is disconnected from the electricity supply and all cables are removed. Remove all loose articles and items of jewellery before working inside the computer cabinet. Work in a well-lit area on a flat, clean, stable surface free of dust and any other small particles or any debris. [. . . ] The components inside your computer are sensitive to electrostatic discharge. You must use the supplied anti-static wrist strap to earth yourself while you work. Make sure you back-up any data before attempting any fix, if you do not, data may be lost. If you are in any doubt as to any of the procedures or instructions please contact us via the Easy Repair line. Before you start You will need the following tools: Philips / Cross-head screwdriver Anti-static wrist strap (supplied in your pack) Using the anti-static wrist strap 1. The end without the strip of copper should be firmly stuck to your wrist, ensuring optimal contact with your skin. Connect the other end, with the strip of copper, to the clear metal surface of the back of your computer. Make sure this connection remains intact during the entire Easy Repair process. Make sure that your computer is disconnected from the electricity supply!Place the hard drive back into the bay inside the PC and replace the 2 retaining screws. Fig. Slide it onto the casing making sure that it is secure and that no cables are trapped. 5. Then push the retaining clip up to lock it into place. or screw the two screws back on. Fig. 14 Securing the side panel Version: 1. 4 EN 2. 0 Packard Bell Easy Repair 5 Hard Disk Drives Step 4 - Re-installing your software Call the help desk and ask them to guide you through the ExtHS process. Please have your Recovery CDs to hand when you call the Easy Repair line. Once you have completed the ExtHS process you will need to re-install Windows and the other software supplied with your Packard Bell computer. Disconnect all peripheral devices (web cam, printer, scanner, broadband modem etc. ). Insert the Packard Bell Master CD 1 / DVD in the top CD / DVD drive and restart your computer. [. . . ] Disconnect all peripheral devices (web cam, printer, scanner, broadband modem etc. ). Insert the Packard Bell Master CD 1 / DVD in the top CD / DVD drive and restart your computer. The CD will load and display the following message: Please refer to the section headed Packard Bell Recovery Program in your user's guide for instructions on this utility. [. . . ]