User manual PACKARD BELL IMEDIA 1605B EASY REPAIR INSTRUCTIONS - HARD DISK DRIVE (ENGLISH)

[. . . ] Packard Bell Easy Repair Hard Disk Drives Important Safety Check Instructions You must read all instructions carefully before you begin work and comply with the procedures set out below. Failure to comply precisely with these instructions could lead to injury and / or may damage your computer. You have elected to fix the component yourself and, therefore, represent you have a basic level of computer knowledge and skill required for fitting. [. . . ] Make sure that your computer is disconnected from the electricity supply!Packard Bell Easy Repair 1 Version: 2. 0 EN 1 Hard Disk Drives Step 1 - Opening the computer casing Before you can start working inside your PC, you will need to remove the side panel. 2 Remove the side panel Version: 1. 4 EN 2. 0 Packard Bell Easy Repair 2 Hard Disk Drives Step 2 - Removing the hard disk drive 1. Turn the computer so that you can see and access the internal components. The grey data cable (IDE or SATA) and a power cable (with a white or black plug). Gently pull these cables out of the drive (hold by the connector and not the cable). Fig. 6 SATA data and power cables Version: 1. 4 EN 2. 0 Packard Bell Easy Repair 3 Hard Disk Drives Step 3 - Installing the new hard drive 1. You need to connect the cable so that the red or black stripe is next to the power cable. SATA data cables Connect the SATA data cables (grey or red) to the hard drive. You will notice it has an `L'-shaped connection and can only be fitted one way. Fig. 8 Connect the SATA cable IDE drive: power cable Connect this cable (white plug) to the socket on the right hand side of the drive with 4 large pins. It can only be connected one way so you cannot get it wrong. SATA drive: power cable Connect this cable (black plug) to the power socket on the drive (the larger socket). 10 Connect the SATA power cables Version: 1. 4 EN 2. 0 Packard Bell Easy Repair 4 Hard Disk Drives 2. Make sure you set the jumper on your new drive to the same position (Fig. Note: You can find a drawing on the casing of the drive which explains which pins are Master, Slave or Cable Select. Place the hard drive back into the bay inside the PC and replace the 2 retaining screws. Fig. [. . . ] Please select option 1 "Standard System Restore" by pressing the 1 key on your keyboard. If there was a Software Library DVD supplied with your PC you can use this to install the extra software that was supplied with your computer. Finally, you will need to install any additional devices (web cam, printer, etc. ) and software by following the instructions supplied with them. Version: 1. 4 EN 2. 0 Packard Bell Easy Repair 6 [. . . ]