User manual MTD UO603

[. . . ] For service, please call the Customer Support Department to obtain a list of authorized service dealers near you. Service on this unit, both within and after the warranty period, should only be performed by an authorized and approved service dealer. Before beginning, locate the unit’s model plate, which lists the model and serial numbers of your unit. Refer to the sample plate below and copy the information for future reference. [. . . ] Before further use, any damaged part should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment of moving parts, binding of moving parts, breakage of parts and any other conditions that may affect its operation. Damaged parts should be properly repaired or replaced by an authorized service center, unless otherwise indicated in this manual. € Use only original manufacturer replacement parts and accessories, which are designed specifically to enhance the performance and maximize the safe operation of the product. € When not in use, store the unit indoors in a locked-up and dry, or high and dry, place to prevent unauthorized use or damage. € SAFETY AND INTERNATIONAL SYMBOLS • This operator's manual describes safety and international symbols and pictographs that may appear on this product. Read the operator's manual for complete safety, assembly, operating, maintenance and repair information. sYMBOL MEANING • SAFETY ALERT SYMBOL Indicates danger , warning or caution. € READ OPERATOR'S MANUAL Read the operator’s manual(s) and follow all warnings and safety instructions. Failure to do so can result in serious injury to the operator and/or bystanders. € WEAR EYE AND HEARING PROTECTION Thrown objects and loud noise can cause severe eye injury and hearing loss. The blower tube and nozzle extend the reach of the blower and concentrate the flow of air it delivers. Slide the widest end of the blower tube over the front opening on the motor housing until the tab on the blower tube is inserted into the opening on the motor housing and locks into place (Fig. Slide the nozzle over the end of the blower tube until the latches on both sides of the blower tube and nozzle lock into place (Fig. NOTE: The blower tube must be used at all times during blower mode to prevent overheating the motor. VACUUM ASSEMBLY Blower Tube Motor Housing OPERATING INSTRUCTIONS WARNING: Do not allow familiarity with this unit to promote carelessness. Remember that a careless fraction of a second is enough to inflict serious injury. 1 WARNING: If any parts are damaged or missing, do not operate the unit until the parts are replaced. WARNING: Always wear appropriate eye and ear protection when operating this unit. Wear safety goggles, or safety glasses with side shields, that are marked as meeting ANSI Z87. Failure to do so could result in serious eye injury caused by thrown objects. Refer to the Safety Information section for appropriate safety equipment. [. . . ] THE MOTOR RUNS, BUT THE UNIT WILL NOT BLOW OR VACUUM CAUSE The impeller (fan) is damaged The tubes, blower opening or impeller is blocked SOLUTION Have the unit serviced by an authorized service center Clear the blockage. refer to Clearing a Blocked Tube or Impeller in the Maintenance and Repair Instructions section. Empty the vacuum bag Clean the vacuum bag Replace the vacuum bag Zip up the vacuum bag The vacuum bag is full The vacuum bag is dirty The vacuum bag is torn The vacuum bag is unzipped NOTE: For maintenance beyond the minor adjustments listed above, or for replacement parts, please call the Customer Support Department at 1-800-828-5500 (U. 6 lb 12 oz (3 kg) * All specifications are based on the latest product information available at the time of printing. [. . . ]