User manual MTD T120

[. . . ] If they do not, have the unit adjusted by an authorized service technician. It will do the job better and with less likelihood of injury at a rate for which it was designed. €¢ Use extreme caution when reversing or pulling the unit towards you. €¢ Do not overreach, take extra care when working on slopes or inclines. [. . . ] ASSEMBLY INSTRUCTIONS NOTE: This unit is shipped without gasoline or oil. In order to avoid damage to the unit, refer to Oil and Fuel Information to put oil and gas in the crankcase before attempting to start it. NOTE: Before setting up your cultivator, disconnect the spark plug wire from the spark plug. Adjusting Tine Depth Tine adjustment will vary depending on the type of soil being cultivated and how it will be used. Generally, adjusting the tines to break the soil 4 to 6 inches is recommended for most gardens. Loosen (do not remove) the two wing nuts (5) on the tine guard (4) (Fig. Slide the wheel down for shallower and up for deeper tine penetration. Once the tines are in the desired position, tighten the wing nuts, making sure that the carriage bolts are seated properly through the bracket (Fig. With the unit upright, swing the handlebars up into the operating position (Fig. NOTE: Take care not to pinch the throttle cable or switch wires when positioning the handlebar. OIL AND FUEL RECOMMENDATIONS RECOMMENDED OIL TYPE Use high quality oil formulated for use in 2-cycle, aircooled engines. Mix the oil according to the instructions on the 2-cycle engine oil container, 40:1 (2. OIL AND FUEL MIXING INSTRUCTIONS Old and/or improperly mixed fuel are the main reasons for the unit not running properly. Thoroughly mix the proper ratio of 2-cycle engine oil with unleaded petrol, 40:1 (2. RECOMMENDED FUEL TYPE Always use clean, fresh, unleaded petrol (gasoline). If fuel hasn’t entered the bulb, press three more times, or until it does. NOTE: Tilt the unit back slightly to bring the tines off the ground when starting. Pull the starter rope (7) out with a controlled and steady motion 3 times (Fig. NOTE: The unit uses Advanced Starting Technology™, which significantly reduces the effort required to start the engine. You must pull the starter rope out far enough to hear the engine attempt to start. There is no need to pull the rope briskly-- there is no harsh resistance when pulling. Be aware that this starting method is vastly different from (and much easier than) what you may be used to. [. . . ] 17 MAINTENANCE AND REPAIR INSTRUCTIONS STORAGE • Never store the unit with fuel in the tank where fumes may reach an open flame or spark. €¢ Store the unit in a dry place, locked up or up-high to prevent unauthorized use or damage. NOTE: Remove the spark plug and drain all of the oil from the cylinder before attempting to start the unit after storage. Repair or replace damaged parts and tighten loose screws, nuts or bolts. [. . . ]