User manual MTD LOG SPLITTER 550

[. . . ] A06 FORM NOK=769-01847 jqa=mêçÇìÅíë=^âíáÉåÖÉëÉääëÅÜ~Ñí==p~~êÄêÅâÉå==dÉêã~åó English Operating Manual for Wood Splitter Information on the rating plate This information is very important for subsequent identification when ordering spare parts and for customer service. Enter all information on the rating plate of your unit in the following field. Safe operating practices Using the unit correctly This wood splitter is designed to be used ­ for splitting firewood for private use ­ in accordance with the descriptions and safety instructions indicated in this operating manual. The user is liable for all injuries to third parties and damage to their property. Arbitrary changes to the unit will exclude the manufacturer from any liability for resulting injury and/or damage. The unit may be operated by one person only. [. . . ] The vertical column lock is situated next to the oil filter, the horizontal column lock on the support of the column holder. Engine controls The positions and functions of the controls for the engine can be found in the enclosed engine manual. 6 English Operating Manual for Wood Splitter Operating the unit Also follow the instructions in the engine manual!Persons, children and/or animals must be kept away from the unit while it is being operated. If the unit is damaged: Immediately switch off the engine and contact a repair shop. When working, always wear protective gloves made of leather, hard-toed boots, ear protection, goggles and tight-fitting clothing. Never attempt to remove partially split wood manually from the splitting wedge. Move the unit away from the spilled fuel and wait until the fuel vapours have evaporated. To prevent the risk of fire, please keep the following parts free of foliage, small twigs and leaking oil: engine, exhaust, fuel tank. Check in particular that the safety devices, covers, holders, controls, hydraulic hoses and threaded connections are undamaged and tight. Do not operate the unit if the hydraulic fluid is colder than ­6 °C or warmer than +65 °C. Before operating the unit, have all damaged parts replaced or repaired by a repair shop. Operating times Observe the national/municipal regulations concerning times of use (if required, ask your local authority). · the tyre pressure (see "Maintenance" section or tyre wall). · air filter area for dirt · lubrication of the splitting column ­ Lubricate the area of the splitting column (where the splitting wedge moves to and fro) with engine oil; do not use lubricating grease. Remember to lubricate the front and rear stops as well. Vertical setting To release the splitting column, pull out the locking pin for the horizontal column lock and tilt the column into the vertical position and lock and secure with the locking pin for the vertical column lock (see Fig. Horizontal setting Pull out the locking pin for the horizontal column lock and rotate downwards. It automatically engages in the horizontal position and is locked. Starting the engine Note: Some models have no throttle, the speed is set automatically. · · · · · · Connect the spark-plug terminal. Set the engine stop switch on the engine (depending on the model) to "ON". Slowly pull the pull-starter handle until it begins to resist, then pull it through quickly and forcefully. Do not let the pull-starter handle spring back, but guide it back slowly. Making settings before using the unit: Caution!Do not make any settings while the engine is running · Remove the spark-plug terminal. [. . . ] After the season or if the unit is not used for more than a month: · Clean the unit. · Protect all metal parts from rust by wiping them with an oiled cloth or spraying them with oil. · Drain fuel (outdoors only) and disconnect the engine as described in the engine manual. · Store the unit in a clean, dry location. Warranty The warranty regulations issued by our company or the importer are valid in all countries. [. . . ]