User manual MTD MTD25P 41AC025P900

[. . . ] English Operator’s Manual STOP ARRÊT ALTO For problems or questions, DO NOT return this product to the store. 1-866-747-9816 CANADA 1-800-668-1238 Made in China / Fabriquè à China / Hecho en China IMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLY P/N 6096-202405 © 2005 PRINTED IN CHINA TABLE OF CONTENTS Warranty Statement Rules for Safe Operation Assembly Instructions Operating Instructions Page 1 Pages 2-6 Page 7 Page 8-9 Maintenance Instructions Specifications Parts List Notes Pages 10-12 Page 12 Page 13 Page 14 RULES FOR SAFE OPERATIOIN The purpose of safety symbols is to attract your attention to possible dangers. The safety symbols, and their explanations, deserve your careful attention and understanding. The instructions or warnings they give are not substitutes for proper accident prevention measures. [. . . ] Failure to do so can result in serious injury to the operator and/or bystanders. CORD RETAINER • WEAR HEAD, EYE AND HEARING PROTECTION LOWER BODY WARNING: Thrown objects and loud noise can cause severe eye injury and hearing loss. AIR OPENINGS DEBRIS SHIELD STRING HEAD NYLON LINE 5 6 RULES FOR SAFE OPERATIOIN SAFETY AND INTERNATIONAL SYMBOLS This operator's manual describes safety and international symbols and pictographs that may appear on this product. Read the operator's manual for complete safety, assembly, operating and maintenance and repair information. rULES FOR SAFE OPERATIOIN KNOW YOUR UNIT REAR HANDLE SYMBOL MEANING • SAFETY ALERT SYMBOL Indicates danger , warning , or caution. SYMBOL MEANING • MINIMUM OPERATING DISTANCE WARNING: Keep children, bystanders, and animals 50 feet (15meters) away. TRIGGER • WARNING - READ OPERATOR'S MANUAL Read the Operator’s Manual(s) and follow all warnings and safety instructions. Failure to do so can result in serious injury to the operator and/or bystanders. CORD RETAINER • WEAR HEAD, EYE AND HEARING PROTECTION LOWER BODY WARNING: Thrown objects and loud noise can cause severe eye injury and hearing loss. AIR OPENINGS DEBRIS SHIELD STRING HEAD NYLON LINE 5 6 ASSEMBLY INSTRUCTIONS If you receive your unit assembled, check each step to insure your unit is properly assembled. Ensure the cord is NOT plugged into a receptacle before this procedure. Make a loop with 8” - 10” (20 - 25cm) of the end of the extension cord. Place the loop into the groove at the end of the rear handle and lock into place as shown in Fig. Plug the extension cord into a receptacle ONLY when you are ready to operate the trimmer. Take out assembly screw bolts, washers, nuts from parts pack and lock into the unit holes (the correspond location are as Fig. First of all, put the nut in the hole, then support the nut with your finger and put plug the bolt and washer in from other side and tighter. When starting the string trimmer for the first time, check that the nylon lines touch or pass over the line-cutting blade. If they are not long enough, press the button and, at the same time, pull the nylon lines (Fig. Connect the plug of the string-trimmer to the extension cord and attach this to the handle. Without letting the trimmer touch the grass, press the switch (A) on the upper handgrip (Fig. Let the string trimmer run for a few seconds and “bump” the string head against the lawn. A short or worn line cuts less efficiently so, to improve its operation on subsequent occasions, tap the spool button lightly on the ground while the trimmer is running. [. . . ] This warranty is limited to ninety (90) days from the date of original retail purchase for any MTD product that is used for rental or commercial purposes, or any other income-producing purpose. hOW TO OBTAIN SERVICE: Warranty service is available , WITH PROOF OF PURCHASE THROUGH YOUR LOCAL AUTHORIZED SERVICE DEALER. To locate the dealer in your area, please check for a listing in the Yellow Pages or contact the Customer Service Department of MTD LLC by calling 1-866-747-9816 or writing to P. Box 361131, Cleveland OH 44136-0019 or if in Canada call 1-800-668-1238. [. . . ]