User manual MTD 410 THRU 458

[. . . ] Inside Back Cover PRODUCT REFERENCES, ILLUSTRATIONS AND SPECIFICATIONS All information, illustrations, and specifications in this manual are based on the latest product information available at the time of printing. SERVICE INFORMATION Service on this unit both within and after the warranty period should be performed only by an authorized and approved service dealer. For service call 1-800-345-8746 in the United States, or 1-800-668-1238 in Canada to obtain a list of authorized service dealers near you. Refer to the sample plate below and copy the information for future reference. [. . . ] Stand between the handlebars and support the unit by placing your right foot on the wheel bracket assembly and gripping the handlebar grip with your left hand (Fig. NOTE: Tilt the unit back slightly to bring the tines off the ground when starting. Stand in the starting position and do not squeeze the throttle control (Fig. When the engine starts, squeeze the throttle control for 15 to 30 seconds. The EZ-Start™ Lever will click off automatically when you squeeze the throttle control. The engine stops while you are squeezing the throttle, go back to step 4. The engine stops before you squeeze the throttle control, hold the throttle control and pull the starter rope until the trimmer starts. If the outside temperature or engine temperature exceeds 90º F and/or the engine repeatedly fails to start, fully squeeze the throttle control and pull the starter rope 3 to 8 more times. 8 9 OPERATING INSTRUCTIONS OPERATING TIPS Dress properly to reduce the risk of injury when operating this unit. ADJUSTING TINE DEPTH Tine adjustment will vary depending on the type of soil being cultivated and how it will be used. Generally, adjusting the tines to break the soil 4 to 6 inches is recommended for most gardens. NOTE: When installed correctly, there will be an "R" and "L" tine on both the sides of the gearbox and the tips of the tines. To prevent serious personal injury, always wear heavy gloves when handling the tines. Put the On/Off Stop Control in the STOP (O) position and disconnect the spark plug wire. The tines are stamped with the letter "R" or "L" to identified their position on each side of the gearbox when facing the front of the unit. Replace the tines and felt washers onto the shaft with the hubs on the tines facing each other. 12 11 L MAINTENANCE AND REPAIR INSTRUCTIONS AIR FILTER MAINTENANCE Removing the Air Filter/Muffler Cover To avoid serious personal injury, always turn the unit off and allow it to cool before you clean or service it. Remove the four (4) screws securing the air filter/muffler cover (Fig. Locate the muffler front and the two (2) bolts securing it to the engine (Fig. Remove the two (2) bolts using a flatblade screwdriver or 5/16-inch socket or nut driver. NOTE: If the exhaust gasket is torn or damaged, replace it with a new gasket before you reassemble the muffler. Using a small flatblade screwdriver, carefully pry up the spark arrestor from the recessed hole (Fig. [. . . ] € Any manufacturer approved replacement part may be used in the performance of any warranty maintenance or repair of emission related parts and will be provided without charge to the owner. Any replacement part that is equivalent in performance or durability may be used in non-warranty maintenance or repair and will not reduce the warranty obligations of the manufacturer • The following components are included in the emission related warranty of the engine, air filter, carburetor, primer, fuel lines, fuel pick up/ fuel filter, ignition module, spark plug and muffler. 19 MANUFACTURER’S LIMITED WARRANTY FOR: The limited warranty set forth below is given by MTD LLC (“MTD”) with respect with new merchandise purchased and used in the United States, its possessions and territories. MTD warrants this product against defects in material and workmanship for a period of two (2) years commencing on the date of original purchase and will, at its option, repair or replace, free of charge, any part found to be defective in material or workmanship. [. . . ]