User manual MTD 3020-0

[. . . ] Fit a shoulder bolt (D1) and nut (E1) to each of the holders (F1) and (G1) ­ Fig. Remove the 4 screws (2 on left and 2 on right) from the rear side of the chassis and use these 4 screws (A1) subsequently for the side holder attachment (Fig. Now attach the pre-assembled holders (F1 and G1) from Step 1 to the tractor using the 8 screws (A1) (Fig. [. . . ] Insert the bolts (B1) into the two holders and secure each bolt with a cotter pin (C1) ­ Fig. Fit the two plates (L1 and K1) to the plate (J1) using 4 screws (H1) and 4 nuts (I1) ­ Fig. Fit the holder (C) to the pre-assembled mounting frame using 4 screws (D2) and 4 nuts (F2). Note: Ensure that correct mounting holes are used in the side retaining plates and initially tighten the nuts only handtight, as this will facilitate the subsequent installation. Now hook the pre-assembled mounting frame into the shoulder screws on the tractor frame/holder (Fig. Note: In the tractor series 700 first remove the retaining bolts (B1) and cotter pins (C1) from the holder (Fig. Then re-attach them after hooking in the mounting frame to secure the mounting frame to the holder as well. 18. Hook both grass catcher bags (G) into the tube holder, ensuring that the more impervious side (closer meshed fabric) is at the front (Fig. Note: First hook in the front side and then lower the rear side until the grass catcher bag is situated firmly in the tubular frame. Fit the rubber mount (N2) to the mower deck connector (B) using the bolt (H2), washer (I2) and safety cotter pin (J2) ­ Fig. Open the impact guard on the mower deck and hold it firmly in this position (Fig. Place the rear upper edge of the mower deck connector over the rear upper edge of the mower deck opening. Note: The connector is correctly installed when the lower edge is situated over the lower edge of the mower deck opening (Fig. Hook the rubber mount into the retaining bolt on the mower deck to secure the mower deck connector on the mower deck (Fig. [. . . ] Note: The connector is correctly installed when the lower edge is situated over the lower edge of the mower deck opening (Fig. Hook the rubber mount into the retaining bolt on the mower deck to secure the mower deck connector on the mower deck (Fig. Align the guide grooves (1) on the intermediate piece (A) with the mounting lugs (2) on the mower deck connector and push the intermediate piece all the way onto the mower deck connector (Fig. [. . . ]