User manual MTD 2060-0

[. . . ] If your unit is for use on less than 150 volts, it has a plug as illustrated in sketch A in Figure 1 on page 2. The green-colored rigid ear, lug, or the like, must be connected to permanent ground, such as a properly grounded outlet box. EXTENSION CORDS Use only three-wire outdoor extension cords that have three-prong grounding plugs and grounding receptacles that accept the appliance’s plug. Proper footing and balance enables better control of the tool in unexpected conditions. [. . . ] Before starting the trimmer, make sure that the luttig blade is not touching stones or debris. When the trimmer is in operation, keep the cutting section away from all parts of the body. Only cut during broad daylight or with corresponding artificial light. Don’t abuse cord, never carry hedge trimmer by cord or yank it to disconnect from receptacle. When the trimmer is not in use, store it in a dry place and out of the reach of children. The mains voltage must correspond to the one marked on the technical data plate. Try to prevent it from getting wet or being exposed to 2 SPECIFICATIONS . When using electric gardening tools, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and personal injury, including the following. GROUNDING INSTRUCTIONS This tool should be grounded while in use to reduce the risk of electric shock to the operator. The tool is equipped with a 3-conductor cord and 3-prong grounding plug to fit the proper grounding receptacle. If your unit is for use on less than 150 volts, it has a plug as illustrated in sketch A in Figure 1 on page 2. Disconnect the plug from the power source before making any adjustment, changing accessories, or storing the tool. Such preventive safety measures reduce the risk of starting the tool accidentally. When not in use, tools should be stored indoors in dry, and high or locked-up lace, out of reach of children. Keep cutting tools sharp and clean for best performance and to reduce the risk of injury. inspect tool cord periodically , and if damaged , have it repaired by an authorized service facility. Before further use of the tool, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting, and any other condition that may affect its operation. A guard or other part that is damaged should be properly repaired or replaced by an authorized service center unless indicated elsewhere in this manual. The power supply cable should be checked regularly and before using it each time make sure the cable is not damaged or old out. Keep it away from the cutting area, from damp, wet or oily surfaces or with sharp edges and away from heat and fuels. Avoid unintentional starting, don’t carry plugged in hedge trimmer with fingers on both switchs. [. . . ] Use the trimmer only for cutting normal shrubbery found around houses and buildings. To obtain exceptionally level hedges, a piece of string can be stretched along the length of the hedge as a guide. 2) To turn the tool ON, squeeze the both triggers on bail handle and body handle with your fingers at same time. To turn the tool OFF, simply release any trigger on bail handle or body handle. [. . . ]