User manual MICROSOFT WIRELESS INTELLIMOUSE EXPLORER QUICK START GUIDE

[. . . ] Extended exposure to high volumes when using a headset may result in temporary or permanent hearing loss. Before boarding any aircraft or packing a wireless device in luggage that will be checked, remove the batteries from the wireless device or turn the wireless device off (if it has an on/off switch). Wireless devices can transmit radio frequency (RF) energy, much like a cellular telephone, whenever batteries are installed and the wireless device is turned on (if it has an on/off switch). Headset Devices Wireless Devices Keyboard and Mouse Devices Health Warning Use of a keyboard or mouse may be linked to serious injuries or disorders. When using a computer, as with many activities, you may experience occasional discomfort in your hands, arms, shoulders, neck, or other parts of your body. [. . . ] The amount of time a person performs an activity may also be a factor. 2 X12-29435-03_Mnl_Product_Guide_w2 2 10/3/2006 11:13:39 AM To select an appropriate power source for your device: Use only the power supply unit and AC power cord that came with your device or that you received from an authorized repair center. Confirm that your electrical outlet provides the type of power indicated on the power supply unit (in terms of voltage [V] and frequency [Hz]). If you are not sure of the type of power supplied to your home, consult a qualified electrician. Do not use non-standard power sources, such as generators or inverters, even if the voltage and frequency appear acceptable. Do not overload your wall outlet, extension cord, power strip, or other electrical receptacle. Confirm that they are rated to handle the total current (in amps [A]) drawn by the device (indicated on the power supply unit) and any other devices that are on the same circuit. To avoid damaging the power cords and power supply: Protect the power cords from being walked on. Protect cords from being pinched or sharply bent, particularly where they connect to the power outlet, the power supply unit, and the device. When disconnecting the power cords, pull on the plug--do not pull on the cord. If a power cord or power supply becomes damaged in any way, stop using it immediately. Unplug your device during lightning storms or when unused for long periods of time. For devices with an AC power cord that connects to the power supply, always connect the power cord according to the following instructions: 1 Plug the AC power cord into the power supply until it stops. If the device is exposed to an environment outside of its prescribed operation, turn off the device and allow the temperature to stabilize within the specified operating range before using the device. All Devices Do Not Attempt Repairs Do not attempt to take apart, open, service, or modify the hardware device or power supply. Any evidence of any attempt to open and/or modify the device, including any peeling, puncturing, or removal of any of the labels, will void the Limited Warranty. Caution Use of controls or adjustments, or performance of procedures other than those specified herein may result in hazardous radiation exposure. Laser and LED Specifications Laser Devices This device complies with International Standard IEC 60825-:200-08 for a Class and Class 2 laser product. This device also complies with 21 CFR 1040. 10 and 1040. 11 except for deviations pursuant to Laser Notice No. 50, dated July 26, 200. 5 X12-29435-03_Mnl_Product_Guide_w5 5 10/3/2006 11:13:39 AM If necessary, ask your computer dealer or an experienced radio-TV technician for more suggestions. For more information about interference issues, go to the FCC Web site at: http://www. fcc. gov/cgb/consumerfacts/interference. html. You can also call the FCC at 888-CALL FCC to request Interference and Telephone Interference fact sheets. For Bluetooth and 2. 4 GHz devices only: To comply with FCC RF exposure requirements, the following operating configurations must be satisfied: the antenna has been installed by the manufacturer and no changes can be made. The wireless devices must not be co-located or operating in conjunction with any other antenna or transmitter. Except for headset and handheld devices, wireless devices must be at least 20 cm between the antenna of the wireless device and all persons. Microsoft Corporation; One Microsoft Way; Redmond, WA 98052-6399; U. S. A. United States: (800) 426-9400; Canada: (800) 933-4750 Disposal of Waste Electrical and Electronic Equipment in the European Union and Other Countries/Regions with Separate Collection Systems This symbol on the product or its packaging means that this product must not be disposed of with your household waste. [. . . ] Contact weee@microsoft. com for additional information on disposal of waste electrical and electronic equipment (WEEE). Patent Information United States and/or international patents pending. Customer Support Options If you have a question about your Microsoft hardware product, do the following: Check the system requirements for your product (located on the packaging) to ensure that your system is compatible. For complete product information, see the on-screen Help file installed with the device software. For the latest product information and software updates, go to the Microsoft Hardware Web site at www. microsoft. com/hardware. Move the hardware device farther away from the radio or TV, or move it to one side or the other of the radio or TV. [. . . ]