User manual KURZWEIL RIBBON

[. . . ] The Kurzweil Ribbon Controller Thanks for purchasing the Kurzweil Ribbon Controller, a programmable-function continuous controller for the Kurzweil PC2 and PC2X. Please read this instruction sheet carefully before using your ribbon controller. Positioning and Attaching the Ribbon Controller The ribbon controller should rest on a flat surface, so that it doesn't bend during use. [. . . ] Wherever you put the controller, keep it in place with either the foam strip or the Velcro® fastener pads. The self-adhering foam strip will hold the ribbon controller in place under most circumstances. To attach the foam strip, remove the backing from the adhesive, and attach the strip to the underside of the ribbon controller. The foam should prevent the ribbon controller from slipping out of position, as long as it's not at a steep angle. For more permanent attachment, use the self-adhering Velcro fasteners instead of the foam strip. Separate the Velcro fasteners into hook halves (rougher) and loop halves (softer, fuzzier). Remove the backing from the adhesive on one of the loop halves, and attach it to the underside of the ribbon controller, near one end. Attach the other loop half near the other end of the ribbon controller's underside. Lightly rejoin the hook halves of the fasteners to the loop halves, aligning them carefully. Position the ribbon controller where you want it, and press it lightly into place. [. . . ] You'll probably want to find a way to fasten the cable so that it doesn't get in your way. Configuring and Using the Ribbon Controller You can use the Large Ribbon as one controller, or divide it up into three smaller sections, each with its own controller assignments. Your PC2 Musician's Guide explains how to choose the number of sections, and how to control the response. Part Number 910352 [. . . ]