User manual KOMPERNASS PARKSIDE PTBM 350-13 BENCH DRILL

[. . . ] By doing this you will be able to work in complete safety and produce better results. Be careful to keep these advice notes and if necessary pass them on to a third party. PROPER USE The bench drill is intended for drilling in wood, plastic and metal using normal drill bits up to a maximum diameter (ø) of 13 mm. Any other use of or modification to the machine shall be considered as improper use and could give rise to serious danger. SPECIFIC SAFETY ADVICE In addition, you must also read the advice in the accompanying booklet called "Safety advice" before using the equipment for the first time. [. . . ] Insert the column ² into the base plate ³ and tighten the screws (3 column/base fixing screws ·). Place the drilling table » on to the column ² and fix it in position using the table clamp screw . Fix the drill vice ´ (4 drill vice screws ¿) on to the drilling table ». The motor unit is attached by two hexagonal socket screws on the right hand side. Attach the three armed handle/spindle control in the rise and fall shaft. Attention: Clean the drill spindle cone thoroughly to remove all traces of grease. SETTING UP THE MACHINE Set the bench drill down on a firm surface and level it using a spirit level. We recommend that the machine is bolted down on to the supporting surface. Please ensure that the base plate ³ is not subject to any additional forces as a result of being bolted down. 5 INSTALLATION AND FIRST USE Check that the supply type, voltage and fuses comply with those specified for the machine. Then oil the column. SWITCHING THE MACHINE ON AND OFF Insert the plug into the mains socket and switch on the machine using the "I" button at the on/off switch º. To switch off use the "0" button. CHECKING AND TENSIONING THE V-BELT Open the drive/belt cover ¸ and check the V-belt tension. If it is correctly adjusted the V-belt should be able to be moved approximately 1 cm in the middle between the two drive wheels. Loosen the adjustment screw and press the motor unit ¶ backwards before retightening the adjustment screw . SETTING THE SPEED The bench drill has 5 different speeds. To do this open the drive/belt cover ¸, loosen the adjustment screw and place the V-belt on the relevant pair of drive wheels. Note: The top pair give the highest speed; the bottom pair the lowest ( =2600, = 1750, = 1250, = 900, = 600, see figure on page 3). Then tension the V-belt as described in the section on "Tensioning the V-belt". Note: Inside the drive/belt cover ¸ there is a contact which must come together with an opposing contact (see ) on the drive/belt casing base when the drive cover is closed. The motor can only be restarted if the drive/belt cover ¸ is properly closed. SETTING THE DRILLING TABLE The drilling table » can be adjusted by loosening the table clamp screw . Set the table so that there is an adequate distance between the workpiece top surface and the drill bit point. [. . . ] In the unlikely event of detecting a functional defect, please return the equipment in its original packaging with the proof of purchase (if available) to the closest service address. Damage caused due to improper handling as well as regular wear of the parts are not covered by this warranty. Beaver Electronic Services · The Lodge, Premier Business Park Long Street, Walsall · West Midlands, WS2 9DY Tel. : 0 19 22/72 55 54 · Fax: 0 19 22/72 54 17 WARRANTY This piece of equipment is covered by a 36-month warranty as of the date of purchase. The equipment was produced with the greatest of care and underwent thorough testing before delivery. [. . . ]