User manual KOMPERNASS PARKSIDE PMS 130-KH 3135 PALM DETAIL SANDER

[. . . ] If you pass the tool on to anyone else, please ensure that you also pass on all the documentation. The sander is intended for dry sanding and polishing of wood, plastic, metal, filler and painted surfaces. It is particularly suitable for working on profiles, sections, in corners or places where access is difficult. [. . . ] Lead poisoning of children and expectant mothers is particularly dangerous. Therefore you should always test the paint on the surface to be sanded using a suitable testing kit or ask the advice of a decorator. Wear a special mask to protect yourself from dust and vapours arising from paint containing lead. Make sure that anyone else near where you are working wears appropriate protection. After finishing work be sure to wash thoroughly before eating, drinking or smoking. Advice on the use of sand paper Coarse sand paper: Medium sand paper: Fine sand paper: is recommended for the quick removal of paint, varnish and rust. Before starting any work on the palm detail sander, make sure that the tool is switched off and the mains plug is out of the socket. Make sure that the holes in the sanding sheet coincide with the holes in the backing plate. When the sanding sheet becomes worn, simply remove it from the backing plate and fit a new one as described above. Before starting any work on the palm detail sander, make sure that the tool is switched off and the mains plug is out of the socket. When sanding wood a suitable suction device designed for that purpose should be attached to the dust extraction adapter . The palm detail sander PMS 130 has a backing plate that can rotate through 360 degrees. This allows you to maintain the best grip on the tool even when working on difficult to access areas. Before connecting to the electricity supply, ensure that the palm detail sander is switched off (switch is in position "0"). Switching on: push the On/Off switch downwards into position "1". Switching off: push the On/Off switch upwards into position "0". Cleaning of working materials, the work place and tool Vacuum the all the surfaces in the working area immediately after finishing work and thoroughly clean them. change the dust bag and the filter on the special suction device regularly. [. . . ] Damage caused due to improper handling as well as regular wear of the parts are not covered by this warranty. This piece of equipment is covered by a 3-year warranty as of the date of purchase. The equipment was produced with the greatest of care and underwent thorough testing before delivery. [. . . ]