User manual KOMPERNASS PARKSIDE PLP 180 SOLDERING GUN

[. . . ] A small wet sponge is ideal for cleaning it Make sure that the joint surfaces to be soldered are bright, clean metal. Remember - a site that has been soldered before cannot be made free of solder residue. This soldering gun is intended for home use only. 4 www. kompernass. com +++ www. kompernass. com +++ www. kompernass. com +++ OPERATING INSTRUCTIONS · · · · Prior to use, draw the soldering tip through the soldering paste which is also supplied. [. . . ] Because the tip melts and wears after lengthy use, it is necessary to replace it at regular intervals. CHANGING THE SOLDERING TIP Unscrew and remove the two fixing screws connecting the tip and the housing. Replace the old tip with a new one and re-insert and tighten the screws. The device is then ready for operation once again. 5 www. kompernass. com +++ www. kompernass. com +++ www. kompernass. com +++ SAFE OPERATION 01. Please make sure that the available mains voltage corresponds to that shown on the rating plate on the equipment. Always turn on the equipment before placing it into contact with the workpiece. Avoid physical contact with earthed parts such as tubes, radiators, stoves, refrigerators. Tools not being used should be stored in a dry, high and closed place, out of the reach of children. Your work is safer and better if carried out within the indicated capacity ranges. Do not use tools for other purposes than those for which they are intended, for example do not use a manual circular saw for cutting tree trunks and timber. Do not wear wide clothes or jewellery since they might be caught by mobile parts. When working in the open, rubber gloves and non-skid footwear is recommended. For work which produces splinters, swarf or dust or when working overhead always wear eye protection, with an appropriate protective mask. If devices for the connection of dust suction equipment and collectors are available, ensure that these are connected and properly used. This guarantees a safer hold than with a single hand and allows you to operate the power tool with both hands. Keep your tools clean and sharp to be able to perform better and safer work. Observe the service instructions and the note regarding change of tools. Check the cable of the tool regularly and in case of damage, ask for professional repair. When power tool is not used, before maintenance and when changing tools, such as saw blade, drill, hob. [. . . ] The equipment was produced with the greatest of care and underwent thorough testing before delivery. In the unlikely event of detecting a functional defect, please return the equipment in its original packaging with the proof of purchase (if available) to the closest service address. Damage caused due to improper handling as well as regular wear of the parts are not covered by this warranty. Beaver Electronic Services · The Lodge, Premier Business Park Long Street, Walsall · West Midlands, WS2 9DY Tel. : 0 19 22/72 55 54 · Fax: 0 19 22/72 54 17 WARRANTY This piece of equipment is covered by a 36-month warranty as of the date of purchase. [. . . ]