User manual KOMPERNASS PARKSIDE PFS 710-KH 3136 SABRE SAW

[. . . ] Please heed the information on saw blades and the advice on ways of working. Any other use or modification of the tool shall be considered as improper use and could give rise to considerable risk of accident. The manufacturer will not accept liability for loss or damage arising from improper use. If the mains lead becomes damaged or severed do not touch the mains lead. [. . . ] There are different saw blades available in various lengths designed to ensure optimum performance of your particular task. 25 mm, 3 TPI Most suitable for: the quick, coarse sawing of wood up to 100 mm thick. Most suitable for: the flexible blade allows flush sawing for coarse work in wood and plastic. Advice about ways of working when sawing Always make sure the saw blade type and the blade speed and oscillation settings are suitable for the workpiece. Before sawing, always check the workpiece for foreign bodies such as nails, screws etc. Switch the tool on and only then bring it into contact with the workpiece. Open the sawn split in the workpiece slightly using a suitable tool and extract the saw blade. Flush sawing: You can use the supplied universal saw blade or a flexible bimetal saw blade to saw projecting workpieces (e. As soon as you have reached the required depth of cut, bring the blade into the vertical position and continue sawing along the cutting line. Finally switch off the sabre saw and lift the blade from the workpiece. Remove the mains plug from the socket before carrying out any tasks on the tool!Wear appropriate protective gloves when fitting and testing the blade. Before replacing the blade, make sure that it is free of any cutting residue (e. If necessary, clean out the saw blade mounting recess with a thin paintbrush or by compressed air. Unscrew the hexagonal socket head screw using the supplied hexagonal socket screw key. Make sure that locating pin engages in the mounting hole in the saw blade. Bend the blade by sideways pressure so that the shoe comes up against the wall. Switch on the tool as described above and trim the workpiece using constant sideways pressure. Plunge sawing: Plunge sawing can be used only in soft materials (such as wood etc. Preparing the saw for use the mains voltage at the plug must match that shown on the rating plate on the tool. shoe: The shoe pivots to adjust to the workpiece and provides safe support to the tool. You can use the oscillating action rotary switch to adjust the effectiveness of the sawing action of the blade to suit the material to be cut. [. . . ] Tips: Sågblad för trä : TPI = teeth per inch = antal tänder per 2, 54 mm Mått : 150 x 19 x 1, 25 mm, 3 TPI Bäst lämpat för: Såga i grovträ upp till 100 m i snabba snitt, även för böjda snitt eller snitt inifrån. This piece of equipment is covered by a 3-year warranty as of the date of purchase. The equipment was produced with the greatest of care and underwent thorough testing before delivery. In the unlikely event of detecting a functional defect, please return the equipment in its original packaging with the proof of purchase to the closest service address. [. . . ]