User manual KOMPERNASS PARKSIDE PFLK 30-KH 3001 SOLDERING PENCIL

[. . . ] Technical information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page Page Page Page 7 7 8 8 GB 5 Table of Content Safety Important specific safety advice . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 8 Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 10 Maintenance and care . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] · The mains voltage at the mains socket must match that shown on the rating plate on the device. Never use a plug adapter in the socket that could possibly earth the device. · Have repairs carried out only by an electrician Technical information Electricity supply: 230 V ~ Frequency: 50 Hz Power consumption: 30 W max. 300° C 8 GB Safety · · or the relevant service centre. Do not operate the device if it is damp and do not use it in a damp environment. If you use the device outdoors, always connect it through a residual current device with a maximum trip current of 30 mA. If using an extension lead, always use one that is approved for outdoor use. Always keep the mains lead out of the operating area and run it away from the rear of the device. In addition, it is recommended that you wear protective gloves, a face mask and a protective apron. Before use, always check the device, mains lead and plug for any damage. If any parts are damaged, have them fixed or replaced at a specialist repair centre only. Ensure that no vapours that may be hazardous to health can accumulate when working with the device for long periods. Switch on the device each time before you bring it into contact with the materials to be soldered. · · · To avoid the danger of injury: Danger of burns!· Before carrying out any work on the device itself, for example, changing the soldering tip, always pull the plug out of the mains socket and allow the device to cool. · Using the device safely: · Before heating the device, check that the soldering tip is firmly seated - the clamping GB 9 Safety/Operation · screw must be fully tightened. When removing the soldering tip make sure that the soldering pencil is switched off and do not use too much force. Place the soldering pencil in the stand during any pauses in your work. Place the soldering pencil down only in the special stand or on a fireresistant support pad. If danger arises, pull the mains plug immediately out of the mains socket. Never use the device for a purpose for which it was not intended. GB · · · · Handle the device carefully and treat it with respect. Do not use the device if you cannot concentrate or you are feeling unwell. · · Operation Note the mains voltage. [. . . ] It has been carefully produced and meticulously checked before delivery. Contact your service centre by telephone in case of questions pertaining to the warranty. This warranty applies only to the initial purchaser and is nontransferable. The warranty covers only material or manu- facturing faults, not normal wear or damage to fragile parts such as switches or rechargeable batteries. If this product has been subjected to improper or inappropriate handling, abuse, or interventions not carried out by one of our authorised sales and service outlets, the warranty will be considered void. [. . . ]