User manual KOMPERNASS PARKSIDE PES 600-KH 3120 RANDOM ORBITAL SANDER

[. . . ] By doing this you will be able to work with a high level of safety and produce better results. Always use a sanding disc and grade of grit suitable for the particular surface you are sanding. Any other use or modification to the random orbital sander shall be considered as improper use and could give rise to considerable dangers. The manufacturer will not accept liability for loss or damage arising from improper use. [. . . ] To help in selecting the most appropriate rotation speed, please refer to our recommendations under "Tips and Tricks". SWITCHING ON AND OFF, CONTINUOUS MODE: TO SWITCH ON: TO SWITCH OFF: TO SWITCH ON IN CONTINUOUS MODE: TO SWITCH OFF CONTINUOUS MODE: 2-STAGE POWER CONTROL: DUO-START DUO-START technology results in high sanding output and allows you two different ways of working with the sander. The two handles allow you to concentrate the sanding power where you want it for the best results, whilst providing you a good control of the sander. You also can work holding either the front handle or the main handle . The front handle can be positioned using the wing screw on the right-hand side. rEDUCED NO-LOAD ROTATION SPEED: The sander has a reduced no-load rotational speed facility. It is only when you press down on the sander or actually sand the workpiece that the full power of the preselected rotation speed is triggered. This means that you can safely bring the sanding disc into contact with the workpiece material and then gently start your orbital sanding process. Press the ON/OFF switch Release the ON/OFF switch Press the ON/OFF switch and lock it in position by simultaneously pressing the locking button Press the ON/OFF switch and then release it. Always switch on the random orbital sander before bringing it into contact with the workpiece material. uSE LIGHT SANDING PRESSURE ONLY Always work applying the lightest possible sanding pressure. The weight of the sander alone is perfectly adequate to produce good sanding results. By adopting this approach you will also prolong the life of your sanding discs, obtain a smoother workpiece surface and reduce the amount of energy consumed. SANDING AND SURFACES The sanding output and the quality of the surface finish are determined by the rotation speed and the grade of grit on the sanding disc (see table under "Advice on use, Tips and Tricks"). The following basic rule applies: the higher the rotational speed, the higher the sanding output and the finer the sanded surface finish. VACUUM DUST EXTRACTION USING THE DUST COLLECTION BOX Push the dust collection box on to the adapter opening on the side of the sander. Note: Empty the dust collection box regularly and at the appropriate intervals, striking the box to dislodge any adhering dirt. VACUUM DUST EXTRACTION USING A VACUUM CLEANER To use a vacuum cleaner for dust extraction you will require the appropriate adapter. Connect the adapter to the hose end piece of your vacuum cleaner and attach it on to the nozzle of the sander. For best results, do this immediately after you have finished using it. [. . . ] In the unlikely event of detecting a functional defect, please return the equipment in its original packaging with the proof of purchase to the closest service address. Damage caused due to improper handling as well as regular wear of the parts are not covered by this warranty. This piece of equipment is covered by a 3-year warranty as of the date of purchase. The equipment was produced with the greatest of care and underwent thorough testing before delivery. [. . . ]