User manual KOMPERNASS PARKSIDE PEH 900 POWER PLANER

[. . . ] By doing this you will be able to work in complete safety and produce better results. Vee groove Base plate Cutting block / planer blades Safety cover Dust channel Rebating depth stop 0 mm 82 mm Weight: Sound pressure level: Sound power level: Vibration: Protection class: 3, 6 kg 087 dB (A) 100 dB (A) 2, 5 m/s2 (hand-arm vibration) II / To be read in conjunction with the advice in the accompanying booklet on safety before using for the first time. If the mains cable is damaged or cut through during the work - never touch the cable - pull out the mains plug immediately. [. . . ] Always switch on the planer before making contact with the material and then guide the planer on to the workpiece Place the planer with the front of the base plate ¾ on the workpiece. Always make sure when you are planing surfaces such as beams and boards that the base plate ¾ is in full contact with the surface to avoid the danger of blade kickback. Always use both hands to guide the plane over the workpiece with even forward pressure. The vee groove º in the centre of the front of the base plate ¾ allows you to chamfer the corners of your workpiece very quickly and easily. Place the planer on to the workpiece with the vee groove º on the corner and then guide the planer along the corner. Example set up: for right hand rebates the side fence ² goes on the left and the rebating depth stop goes on the right into the holes on the planer (with the planer viewed from above). WARNING: Before doing any work on the planer always pull out the plug from the mains. IMPORTANT ADVICE: Do not unscrew the two hexagonal socket headed screws. Adjustment is only required if you wish to change to another planer blade type e. When you change blades, always change both blades to avoid any imbalance. When they become blunt, the PARKSIDE reversible blades can be changed without any height adjustment of the cutting block being necessary 1) 2) 3) 4) First unscrew one cutting block µ only so that you can use the works-mounted second cutting block as an aid to setting up later. Unscrew the three screws in the cutting block µ using the supplied open spanner. 6) Check again for safety: - the position of the planer blade in the cutting block - the balanced and secure seating of the cutting block and the 3 fixing screws - that the height adjustment is correct (2 hexagonal socket headed screws). Unscrew the screws in the cover and take off the toothed belt cover ¶. Cut through the toothed belt with side-cutting pliers or a knife and remove the severed toothed belt. Always clean off any dirt or debris from the pulley and the drive wheel before installing the new belt. [. . . ] Montera parallellanslag ² till vänster och falsdjupanslag till höger i borrhålen på hyveln (montering sett från ovan) för att få en högerliggande fals. This piece of equipment is covered by a 36-month warranty as of the date of purchase. The equipment was produced with the greatest of care and underwent thorough testing before delivery. [. . . ]