User manual KOMPERNASS PARKSIDE PABS 18-2 SL 2 SPEED RECHARGEABLE ELECTRIC DRILL DRIVER-2004-

[. . . ] : in 2nd gear with a 3 mm drill bit in softwood: in 1st gear with a 10 mm drill bit in (ST37) steel strip: in 1st gear with a 20 mm drill bit in softwood: The power consumption can reach over 1000 W. As the speed of the motor drops, the speed of the fan reduces and this may lead to the motor overheating. Important safety advice for the charger and the battery pack warning!If you come into contact with alkali from the battery pack, wash off the alkali thoroughly with water. [. . . ] Before inserting the battery pack into the charger or removing it from the charger, always ensure the plug is not in the mains socket. The green charging light lets you know when charging is complete and the battery pack is ready for use. If you wish to charge a second battery pack, pull out the plug from the mains supply and keep the charger off for at least 15 minutes. Note: If you do not remove the plug from the mains socket before the second charging process starts then the second battery cannot be charged. A new battery pack is not charged and must be fully charged before first use. Never charge the battery pack again immediately after a fast charging process has been completed. This can give rise to the battery pack being overcharged and a reduced life of the battery and charger. Switch off the charger for at least 15 minutes between charges by removing the plug from the mains socket. If you use a multiway socket adapter, unplug all other electrical equipment from the adapter. This ensures that for typical working and handling situations the drill is at the correct angle to the workpiece surface. In this way you can work precisely and much more effectively ­ try it out yourself . The particularly generously-sized controls make it particularly quick to adjust the way the tool works to the suit the task in hand. The SOFTGRIP handle reduces vibrations and makes working with your drill more comfortable, refer to Fig. In second gear (switch in setting: Drill/2) the speed is up to approx. The integral electric brake ensures the tool comes to a halt almost immediately, so that you can work more safely and quickly. All lights on = full power / battery fully charged Before you start screwdriving you can set the torque selector in any of 16 torque settings to obtain the desired torque. Start off with a low setting (1 or 2 on the scale ) and try increasing it by stages until the best setting is reached. By doing this, screws can be driven to a predetermined depth, which is ideal for repetitive work. Slide the selector forward (setting: Drill) to work with the tool set at its optimum for drilling. To take screws out, just reverse the direction by moving the switch to rotate the shaft anticlockwise. The integral electric brake ensures the shaft quickly stops rotating ­ as soon as the trigger switch is released ­ so that you can get to work again fast. When screwing into wood, metal and other materials you must always observe the following advice: 1. [. . . ] Defective or exhausted batteries must be recycled in accordance with Directive 91/157 EEC. Please refer to the special safety advice in relation to the charger and battery pack. We reserve the right to make technical modifications in the course of further development. It has been carefully produced and meticulously checked before delivery. [. . . ]