User manual KOMPERNASS LERVIA KH 230 LAMINATING DEVICE

[. . . ] laminating thickness Laminating speed Roller temperature AC 230 V ~ 50 Hz 200 W 336 x 146 x 75 mm 1, 56 kg 230 mm 1, 0 mm 0, 3 m/Minute 120° C Safety information Setting up the laminating device: · The machine should not be set up in a damp area or in the vicinity of an air conditioning outlet in order to prevent the occurrence of surface leakages. · Ensure that the laminating device is set up upon a level, rigid and non-slip surface. There must be sufcient space behind the device to allow laminated lms to exit. [. . . ] Drawings on heat-sensitive paper and/or material, whose colour and/or quality can be effected by heat Operating the laminating device 1. Cold laminating Plug the laminating device's plug into the power supply socket. The green light designating "POWER" shines, showing that the device is switched on. Place the material to be laminated in a suitably sized lm pouch and feed it into the laminating device. Hot laminating Plug the laminating device's plug into the power supply socket. The green light designating "POWER" shines, showing that the device is switched on. The motor starts to run and the device warms up to its operating temperature. The red light shines after a warm-up phase of 4­8 minutes; the rollers have now reached their operating temperature. Then feed the lm pouch into the laminating device's infeed opening. Ensure that the material being laminated lies directly on the fold of the lm pouch prior to the laminating. The lm pouch must be fed into the laminating device with the fold in front. In order to prevent creasing do not feed the lm pouch in with the open side facing into the laminating device. Pay attention to the pictograph on the infeed opening in order to ensure that the lm pouch is fed into the device correctly. Additional processing of the laminated lm pouch When the lm pouch comes out of the machine after the laminating process it is very hot and can easily lose its shape. [. . . ] The device must be completely dry prior to being used for laminating again!If the paper gets jammed and blocks the movement of the rollers because the paper can not be pulled out of the device, switch the machine off immediately and pull out the plug. Then contact your local laminating device representative or the local service partner. 3 Declaration of conformance We, Kompernaß Handelsgesellschaft mbH, Burgstr. [. . . ]