User manual KOMPERNASS LERVIA KH 1410 CYCLONE VACUUM CLEANER

[. . . ] · Prevent the appliance from coming into contact with moisture!· Do not place the appliance close to fires, sources of heat or prolonged ambient temperatures of over 50° C!· When not in use, disconnect the appliance from the power source and pack the power cord away!· Arrange for defective power plugs and/ or cables to be replaced at once by qualified technicians or our Customer Service Department. [. . . ] Changing tools When you want to change the tool, proceed as follows: 1. Select the desired tool: Floor tool f: To vacuum carpets or hard floors. Attention!Store the no longer required tools as far as practicable in the accessory bracket 2). Operation Attention!Before every utilisation check to ensure that all filters are correctly inserted and that no openings are blocked. Pull the power cable o from the cable storage up to the yellow marking. Should the red marking on the power cable o be visible, rewind the power cable o, by pressing on the foot button for power cable rewind i, back to the yellow marking. Adjust the suction power with the suction power regulator u. Crevice tool 2$: To vacuum dust from difficult to reach locations. Upholstery brush 2%: To vacuum dust from upholstery or other fabric surfaces. 2. If you are using the floor tool f, adjust the setting for carpet/hard floor d with the selector switch: · Press the carpet/hard floor selector switch d to the rear for hard floor surfaces such as laminates, tiles and PVC etc. · Press the carpet/hard floor selector switch d to the front for carpeted surfaces, such as long or short pile carpets and rugs etc. When vacuuming, pay heed to the information providet by the floor covering manufacturer. Hold the power plug o firmly and press on the foot button for power cable rewind i. Allow the power cable o to pull itself in slowly. Emptying the dust collector Empty the dust collector h at the latest when the MAX marking is reached or the suction power has noticeably diminished. Before emptying the dust collector h, remove the plug o from the power socket. Hold the dust collector h low over a dustbin and press the dust collector unlock button . Close the housing lid s. -7- Storage · During work breaks place the storage hook g in the storage bracket a. · If you do not intend to use the vacuum cleaner for an extended period, shorten the telescopic tube 1( as much as possible and place the storage hook l in the storage bracket r. · If you do not intend to use the vacuum cleaner for an extended period, empty the dust collector h and clean both it and the filters (see the chapters "Filters" and "Cleaning and care"). · Store the vacuum cleaner at a cool and dry location. The filters can become blocked after a period of time. Lamellen filter To take the lamellen filter out, proceed as follows: Attention! [. . . ] Notice: Should the motor protection filter be heavily soiled, rinse it thoroughly under clean running water. Before taking the filter out, remove the plug o from the power socket. Press the locking device of the exhaust filter cover e in the middle and at the same time pull the exhaust filter cover e away from the vacuum cleaner to open it. Notice: Should the exhaust filter be heavily soiled, rinse it thoroughly under clean running water. [. . . ]