User manual KOMPERNASS KH 4012 DECORATIVE-NATURAL-STONE INDOOR WATER FOUNTAIN

[. . . ] Remove the enclosed screws from the cable holder fitted to the rim of the aluminium water basin with a screwdriver and remove the plastic clip. Turn the natural-stone bank aside, having the bottom downside with its base in front. [. . . ] Never leave the natural-stone water fountain unattended during operation, this to ensure that in the case of malfunctions the power supply is disconnected. It is most important to check the water level in the water basin during operation!If the natural water pump is in operation and the water level in the water basin is too low, overheating may cause damage to the water pump! Connect the plug of the water pump power cable to the plug of the transformer power cable. If the water basin has a low water level and the pump is not completely covered by water while the natural-stone water fountain is in operation, please unplug the transformer and fill the water basin with distilled water up to the , , MAX" mark before starting again. You will now be able to adjust the pumping rate with the rotating switch at the front of the water pump: · ⷠRotate towards "MIN" for lower pumping rate Rotate towards "MAX" for higher pumping rate The pumping rate of the water pump is infinitely variable and allows to adjust higher or lower water flow when the naturalstone water fountain is in operation. Replace the natural-stone "cascade" body to its original position on the natural-stone bank and place the decorative stones in the water basin. From dust) may cause malfunction during operation; this may cause damages to the water pump!Carefully take the natural-stone "cascade" body from the natural-stone bank. Take the natural-stone bank with the fixed water pump out of the water basin. Disconnect the water pump power cable from the transformer power cable. Take the natural-stone "cascade" body with the fixed water pump from the natural-stone bank. [. . . ] Insert the plug of the water pump power cable to the plug of the transformer power cable. In case the water pump was not covered by water overheating of the pump may result from the low water level. [. . . ]