User manual KOMPERNASS KH 3236 5 IN 1 MULTI-MEASUREMENT DETECTOR WITH LASER

[. . . ] · Do not use the appliance at locations where there is a danger of fire or explosion, e. g. · Do not place any open sources of fire, like candles, on the device. The laser can cause serious eye damage. 4 KH3236_UK_5_in_1_UK. qxd 31. 01. 2007 15:44 Uhr Seite 5 · Do NOT direct the laser beam at strongly reflective material. · Do NOT use the appliance to determine the alternating voltage in exposed or non-insulated power cables. [. . . ] Take note of the following illustrations: 8 KH3236_UK_5_in_1_UK. qxd 31. 01. 2007 15:44 Uhr Seite 9 Fig. 1 The further you are from the wall, the wider is the area (a) that the Multi-Measurement Detector must measure by ultrasound (Fig. Therefore take care that the Manifold Measurer is always directed at a right angle towards a level surface (Fig. Ensure that there are no objects positioned within the measurement area. 3 9 KH3236_UK_5_in_1_UK. qxd 31. 01. 2007 15:44 Uhr Seite 10 The display illumination glows during the measurement. If a button is not pressed within ca. 15 seconds, the illumination extinguishes. Press the button READ , to reactivate the display and the illumination. If the battery is too weak, the battery symbol appears in the display. Adding distances together You can add the measured distances together: 1. In the display , "+" appears and the distance measured carries itself over to the lower line. The new measurement is added to the old measurement in the lower line. All values are erased. 10 KH3236_UK_5_in_1_UK. qxd 31. 01. 2007 15:44 Uhr Seite 11 Measuring areas 1. In the upper line the measured length appears and 'W" (Width) starts to flash. The measured width appears on the upper line and the result of the area calculation in the lower line. Adding areas together 1. Measure an area as described in the section "Measuring areas". Both measurements are added together and the result is shown in the lower line. All values are erased. 11 KH3236_UK_5_in_1_UK. qxd 31. 01. 2007 15:44 Uhr Seite 12 Measuring volumes 1. In the upper line the measured length appears and 'W" (Width) starts to flash. In the upper line the measured width appears and 'H" (Height) starts to flash. In the lower line appears the result of the volume calculation. Adding volumes together 1. Measure a volume as described in the section "Measuring volumes". [. . . ] Should the Multi-Measurement Detector not find anything, then the object is wood. In this case, search again at a different position in the mode "STUD" and repeat steps 1 to 3. Laser marking The appliance contains a Class II laser. You can use laser marking for the exactly horizontal positioning of pictures, shelves etc. 15 KH3236_UK_5_in_1_UK. qxd 31. 01. 2007 15:44 Uhr Seite 16 1. A laser line is projected. Horizontal laser line Attention Exercise caution with the holding pins. [. . . ]