User manual KOMPERNASS KH 3217 SAFETY MAGNET LOCK SET

[. . . ] Safety Magnet Lock Set Package contents Required installation tools Phillips head screwdriver Drill 7 mm drill bit Sharp object for making marks (such as a nail) Assembly Note: Do not drill through the letters in the installation template q, always drill through the marking (X). Please note that when installing the safety magnet lock in drawers, a free space of 4 x 6 cm is required. Remove the narrow sticker from the installation template q and stick it onto an appropriate place on the cabinet inside wall (see Fig. [. . . ] Mark the two new screw holes for the lock plate r with a sharp object (such as a nail). While closing the door, mark the position of the installation template q on the narrow part of the inside of the door using a pencil. Carefully remove the installation template q from the inside cabinet wall. Stick the installation template q onto the previously marked position, flush against the inside edge of the door using the sticker (see Fig. Smooth out the installation template q and mark four of the six screw holes (X) (two above and two below) for the lock w. Fig. Slide the drilling depth limiter u onto the 7 mm drill bit based on the door thickness so that the drilled hole will reach to 3 mm from the front of the door / drawer (Fig. Check whether the magnet connector of the lock w fits perfectly into the hole with the T-insert o (see Fig. 5 Unlocking bar If you do not wish to use the lock, you can permanently unlock the lock with the unlocking bar t. Press the unlocking bar t over the lock w so that the pins snap into the holes first on one side, then on the other side. Press the lock latch closed and turn the unlocking bar t forward until reaching the stop (see Fig. To lock the door, make certain that the unlocking bar t is turned back (see Fig. 7 Warranty and service This product comes with a 3-year warranty as of the date of purchase. Kompernas Service Ireland c/o Irish Connection 41 Harbour view Howth Co. Dublin Tel. : 087 9962077 Fax. : 18398056 e-mail: support. ie@kompernass. com 5. Set the drill against the inside of the door / drawer on the marking (X) 7 mm on the installation template q (see Fig. 3) and drill the hole until the drilling depth limiter u rests against the inside of the door / . [. . . ] Do not keep the mag-net key e in a clothing pocket and never inside the cabinet being secured. Disposal Do not throw the magnet lock into normal household waste. Dispose of the magnet lock through an approved waste disposal company or your community disposal facility. In case of doubt, please contact your waste disposal centre. Kompernaß GmbH Burgstraße 21 D-44867 Bochum www. kompernass. com ID. [. . . ]