User manual KOMPERNASS KH 3173 MOBILE HYDRAULIC VEHICLE JACK

[. . . ] KH3173_IB_UK. qxd 12. 06. 2006 15:35 Uhr Seite 1 UK Kompernaß GmbH · Burgstrasse 21 · D-44867 Bochum www. kompernass. com ID Nr. : KH3173-03/06-V2 KH3173_IB_UK. qxd 12. 06. 2006 15:35 Uhr Seite 2 Mobile Hydraulic Vehicle Jack KH 3173 Operating instructions KH3173_IB_UK. qxd 12. 06. 2006 15:35 Uhr Seite 3 KH3173_IB_UK. qxd 12. 06. 2006 15:35 Uhr Seite 4 KH3173_IB_UK. qxd 12. 06. 2006 15:35 Uhr Seite 3 KH3173 Mobile Hydraulic Vehicle Jack KH 3173 Keep this manual for future reference and pass it on with the device to any future owners! Intended Use The Mobile Hydraulic Vehicle Jack is intended for the short term lifting of motor vehicles and only for domestic use. The Mobile Hydraulic Vehicle Jack is not intended for permanently holding raised motor vehicles in position and is not intended for use in commercial or industrial areas. Safety instructions · Only use the Mobile Hydraulic Vehicle Jack if it is in a faultless condition. [. . . ] 120 - 355 mm Rotation range for lifting lever: 180° Hydraulic oil for Mobile Hydraulic Vehicle Jack Oil viscosity : SAE 10 DESCRIPTION OF THE APPLIANCE Lifting lever Carrying grip Loading plate Release valve Lifting lever collet -3- KH3173_IB_UK. qxd 12. 06. 2006 15:35 Uhr Seite 4 KH3173 Preparatory steps 1. Place the lifting levers onto the release valve at the front. Turn it clockwise to close it completely. Turn the lifting levers clockwise until they are secure against being pulled out. On the first utilisation or after an extended period of non-usage, first pump the Mobile Hydraulic Vehicle Jack without any loading (6-7 pump movements). This distributes the hydraulic oil evenly again inside the device. 3. Now raise the vehicle until you have sufficient clearance to position the axle stands. Permit the vehicle to drop onto the axle stands in that you slowly open the release valve by turning it in an anti-clockwise direction. Lowering the vehicle 1. Then, with the lifting lever , slowly turn the release valve (anti-clockwise) and carefully allow the vehicle to descend. As soon as the Mobile Hydraulic Vehicle Jack is removed from under the vehicle, the loading plate can be completely pressed down with the foot. Raising the vehicle Cleaning and Care Important: Refer to the vehicle owner's handbook to find out where the lifting points are located. Push the loading plate to exactly in the middle below the lifting point. [. . . ] Related harmonised standards: EN 1494:2000 Kompernaß Handelsgesellschaft GmbH Burgstr. 21, D 44867 Bochum Bochum, den 06. 06. 2006 Hans Kompernaß, General Manager -5- [. . . ]