User manual KOMPERNASS EBENCH KH 20 RADIO ALARM CLOCK

[. . . ] · Radio alarm clock · Radio alarm clock silber/silver 1 3 2 4 5 6 7 8 9 10 15 16 13 12 11 14 RADIO ALARM CLOCK KH20 RADIO ALARM CLOCK KH20 INTRODUCTION Before using the radio alarm clock please read these instructions carefully so that you become familiar with the operation and features of this device. OPERATIONAL CONTROLS (1) Alarm sign (LED) (2) Hour (HOUR) (3) Minute (MINUTE) (4) Time (TIME) (5) Wake-up (ALARM) (6) Off (AL/OFF) (7) Alarm sign (SLEEP) (8) Pause (SNOOZE) (9) Radio station (TUNING) (10) Band selection (FM/AM) (11) Volume (VOLUME) (12) FM aerial (13) Battery compartment for power failure protection (14) Power cable (15) Dimmer (HI/LO) (16) Auto display radio/buzzer on/off (AUTO/BUZZ/ON/OFF) Set the auto switch (16) to the "AUTO" position. · Alarm by buzzer: Set the auto switch (16) to the "BUZZ" position. · You can interrupt the alarm action (the playing of the radio or the signaling of the buzzer) by pressing the pause button (8) (SNOOZE). [. . . ] Once the buttons have been released the display will switch back to showing the current time. · If you want to switch the radio off before the time set, press the pause button (8) (SNOOZE). CONNECTION Connect the power cable (14) to an electrical socket. Please ensure that the voltage is correct (230V/50 Hz) in order to avoid possible damage. When the clock is first connected and at every power failure the display will start to flash. RADIO RECEPTION · · · · · · · Switch the auto switch (16) to the "ON" position. Switch the band selection (10) onto the desired wavelength (FM or AM). Use the tuning control (9) (TUNING) to set the station of your choice. In order to optimize FM reception, extend the aerial (12) as far as possible and set it up. In order to optimize AM reception, turn the whole device into the best situation for reception. To switch the radio off set the auto switch (16) to the "OFF" position. POWER FAILURE PROTECTION WITH BATTERY In order to avoid the time and alarm time stored being deleted during an interruption of the electricity supply (e. g. through power cuts, lightning) the device comprises a special compartment (13) at the back that can take a 9V block battery (battery not included). This battery will cause the clock to continue running during a power failure (the radio and the LED display, however, will only work if connected to a mains supply). It is recommended to check the battery about every 3 months by pulling the mains plug out of the socket and putting it back in after one minute. Use leak-proof batteries in order to avoid damage to the device. CONTROL OF TIME AND ALARM · Control and adjustment of time: Press down the buttons "TIME" (4) and "HOUR" (2) simultaneously until the desired hour appears on the display. Press down the buttons "TIME" (4) and "MINUTE" (3) simultaneously until the desired minute appears on the display. [. . . ] In case of repairs please contact our customer service (for address and telephone number see guarantee slip). Please do not place objects containing liquids, such as vases, on the device. Ensure adequate circulation of air!The normal air circulation in and around the device must not be obstructed in any way. ALARM BY RADIO OR BUZZER · Set the time for the alarm as described in the chapter on "Control and adjustment of time and alarm". [. . . ]