User manual KOMPERNASS BIFINETT KH 2210 WATER KETTLE WITH THERMOSTAT TUNER

[. . . ] KH2210_IB_UK 11. 09. 2006 14:57 Uhr Seite 1 UK Kompernaß GmbH · Burgstrasse 21 · D-44867 Bochum www. kompernass. com ID-Nr. : KH 2210-09/06-V1 KH2210_IB_UK 11. 09. 2006 14:58 Uhr Seite 2 Stainless steel electric water kettle with thermostat KH 2210 Operating instructions KH2210_IB_UK 11. 09. 2006 14:58 Uhr Seite 3 KH2210_IB_UK 11. 09. 2006 14:58 Uhr Seite 4 º KH2210_IB_UK 11. 09. 2006 14:58 Uhr Seite 3 bifinett KH 2210 Stainless steel electric water kettle with thermostat KH 2210 Intended Use · This appliance is not for commercial or outdoor use. · The electric water kettle is exclusively suitable for heating water and may not be used for heating other liquids. Describtion of the appliance Chute Release button Indicator lamp On/Off switch Level indicator Temperature regulator Base station º Kettle Danger of electrical shock · Make sure that the base with the electrical connections does not come into contact with water!Let the base dry completely before using, should it ever accidentally become wet. [. . . ] You can thus prevent the appliance from being damaged · Use the kettle º only in the base station provided for the same . · Do not expose the base station to any liquids and protect it from splashes. · Do not separate the kettle º from the base station while the appliance is in operation. · An improper use or handling of the appliance may lead the appliance to malfunction and cause injuries to the user. · No liabilities shall be accepted for damages caused by improper or wrong use. Clean the kettle º, by pouring water into it and bringing it to a boil (See "Boiling water"). Pull it out by opening the base station and connect the plugs with an appropriate power socket. - atleast up to the MIN mark, so as not to overheat the electric water kettle. ­ no higher than the MAX mark so that no boiling water spills out. The appliance can only be switched on if it is fixed to the base station. The On/Off switch automatically moves to the "O" position, the indicator lamp turns off. If you want to stop or interrupt the boiling process, keep the On/Off switch on the "O" position. However, you can continue the boiling process by waiting for 20 seconds until the heating element has cooled off. You can then switch on the appliance once again. -4- KH2210_IB_UK 11. 09. 2006 14:58 Uhr Seite 5 bifinett KH 2210 During the cooling phase, do not press the on/off switch , as this can damage the appliance. With the temperature regulator , you can set the desired water temperature. In order to bring the water to a boil, set the temperature regulator to MAX. [. . . ] Always unplug the power cord from the socket, before cleaning the base station . · Clean the outer side of the kettle and the base station with a soft, damp cloth. For this use a decalcifying agent available with specialised dealers. -5- [. . . ]