User manual KOMPERNASS BIFINETT KH 1134 PLASTIC WATER HEATER WITH THERMOSTAT

[. . . ] It is not intended for use with other liquids or for commercial use. 4. Safety Instructions To avoid the risk of fatalities from electric shocks: Make certain that the base with the electrical connections never comes into contact with water!Let the base become completely dry before using if it has accidentally become wet. [. . . ] That helps you save electricity, water and time: · Lift away the kettle for filling!· Open the lid by pressing down on the unlocking button . · Hold the kettle vertically while filling. Only then will the level indicator on the side correctly indicate the water volume. ­ at least to the MIN mark so that the device does not overheat, ­ no higher than the MAX mark so that no boiling water spills out. · then place the kettle on the base until it sits straight on the base . · Set the desired water temperature using the temperature control . To bring the water to a boil, you must set the temperature controller to the MAX position. · The operating light indicates that the device is now heating up. ar w mr ange Transitionrange kee p ng boili ra nge MIN MAX -4- KH1134_Wasserkocher_IB_UK_neu 16. 10. 2006 13:45 Uhr Seite 5 bifinett KH 1134 Temperature regulator in the boiling range: · The devices switches off automatically and the operating light goes out as soon as the water is at a full boil. In order to keep the water warm after bringing it to a boil, set the temperature regulator in the keep warm range. Temperature regulator in the keep warm range: The left end of the keep warm range indicates the lower temperature. The right end of the keep warm range indicates the higher temperature. · After reaching the desired temperature, the appliance switches off the heating process. Because the device is equipped with a heat maintenance function, the device automatically begins reheating as soon as the water temperature falls below the set temperature. Make sure that the appliance does not automatically switch on to the keep warm function. · As soon as the kettle is lifted from the base , the ON/OFF switch jumps out and the operating lights switch off. · In order to halt the heating process, push the ON/OFF switch up again. Avoid setting the temperature regulator in the transition range, as the water can start boiling on account of varying filling levels. [. . . ] · Press down on the edge of the spout screen from above in order to remove it toward the inside. · After cleaning, insert the screen from above and press it firmly into place. 8. · Wind the power cord around the holder on the bottom of the device. [. . . ]