User manual KINGSTON KVR1333D3E9S2GI MEMORY MODULE SPECIFICATIONS

[. . . ] [. . . ] The SPD is programmed to JEDEC standard latency 1333MHz timing of 9-9-9 at 1. 5V. The electrical and mechanical specifications are as follows: FEATURES: JEDEC standard 1. 5V ± 0. 075V Power Supply VDDQ = 1. 5V ± 0. 075V 667MHz fCK for 1333Mb/sec/pin 8 independent internal bank Programmable CAS Latency: 5, 6, 7, 8, 9, 10 Posted CAS Programmable Additive Latency: 0, CL - 2, or CL - 1 clock Programmable CAS Write Latency(CWL) = 7(DDR3-1333) 8-bit pre-fetch Burst Length: 8 (Interleave without any limit, sequential with starting address "000" only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS] Bi-directional Differential Data Strobe Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%) On Die Termination using ODT pin On-DIMM thermal sensor (Grade B) Average Refresh Period 7. 8us at lower then TCASE 85°C, 3. 9us at 85°C < TCASE . 95°C Asynchronous Reset PCB : Height 1. 180" (30. 00mm), double sided component PERFORMANCE: CL(IDD) Row Cycle Time (tRCmin) Refresh to Active/Refresh Command Time (tRFCmin) Row Active Time (tRASmin) Power UL Rating Operating Temperature Storage Temperature 9 cycles 49. 5ns (min. ) 110ns 36ns (min. ) 1. 350 W (operating) 94 V - 0 0o C to 85o C -55o C to +100o C Document No. VALUERAM0814-001. A00 07/31/09 Page 1 ValueRAM MODULE DIMENSIONS: TECHNOLOGY 30. 00 Units: millimeters 133. 35 18. 80 15. 80 11. 00 8. 00 0. 00 0. 00 54. 70 Document No. [. . . ] [. . . ]