User manual KAWAI KX5000

[. . . ] â· If there is too much noise or vibration, check whether the four levelling adjustment legs are evenly and firmly on the floor. Before using your washing machine, you must remove the shipping bolts from the back of the unit. For more information on removing the safety devices, refer to the user manual. [. . . ] Unscrew the emergency drain cap and pull out the emergency drain tube to drain off the remaining water. Hold the cap on the end of the emergency drain tube and allow all the water to flow into a bowl. Replace the debris filter, the emergency drain cap and tube and then close the filter cover. Level your washer by turning the adjustable nut in and out, as shown in the figure. When your washing machine is level, tighten the locking nut using the (-) driver. If you open the debris filter when water remains inside the tub, water may flow out. If the debris filter is assembled incorrectly or not installed, it may cause a water leakage or operating error. indication Symptom When the door is opened Action Is the door opened?If you insert more than the maximum drying capacity specified in the user manual, the drying performance may decrease. When the water does not drain Is the washing machine frozen because of the cold weather?If fabric softener is inserted above the reference line (MAX) of the fabric softener compartment, fabric softener may enter directly into the tub. â· Insert fabric softener only up to the reference line (MAX) so that it does not overflow. If the rinse cap (hereafter cap) is not inserted correctly or there is foreign material in the cap when using concentrated fabric softener (liquid fabric softener of a high viscosity), fabric softener or water may remain. â· Check whether the cap is correctly inserted into the detergent compartment where the fabric softener is inserted. [. . . ] â· Check whether the cap is correctly inserted into the detergent compartment where the fabric softener is inserted. Only the Power and Start/Pause buttons operate while the `Hot' indication displays. When the internal temperature of the drum is high, the door does not open. [. . . ]