User manual KAWAI K3M

[. . . ] Shall not be responsible in any way for lost profits or any claims by third parties in case of any damage occurring from improper use of this product. Please read the following items before use This Case is a precision device designed for use at a water depth within 40 m. Please use the Case correctly after sufficient understanding of the contents of this manual in regard to handling of the Case, checks before use, maintenance, and storage after use. Shall in no way be responsible for accidents involving immersion of a digital camera in water. [. . . ] Memo: The Case operation parts marked by * corresponds to the operation parts of the digital camera. When the operation parts of the Case are operated, the corresponding functions of the digital camera will operate. For details of the functions, refer to the instruction manual for the digital camera. EN 10 Using the accesories Install the strap Install the strap on the Case body. Installation illustration Installation completed En Hand strap Hand strap ring How to use the hand strap Pass your hand through the hand strap and adjust the length with the stop button. Stop button Mounting and removing the lens cap Fit the lens cap onto the lens ring as shown in the figure. Advance Check of the Case Advance check before use En This Case has been the subject of thorough quality control for the parts during the manufacturing process and thorough function inspections during the assembly. In addition, a water pressure test is performed with a water pressure tester for all products to confirm that the performance conforms to the specifications. However, depending on the carrying and storage conditions, the maintenance status, etc. Advance Check 1 Before installing the digital camera in the Case, immerse the empty Case to confirm that there is no water leakage. We recommend to immerse the empty Case to the intended water depth, however, if you cannot perform this way, check the Case by referring "Water Leakage Test" (P. 2 Operate the control buttons on the Case and confirm that the camera functions properly. 3 Press the shutter button on the Case and confirm that the camera shutter releases. EN 16 Perform the final checks Visual Inspection After sealing the Case, check the sealing part of front and rear lid visually to confirm that the O-ring is not twisted or out of the groove and that no foreign matter has been caught. CAUTION: Hairs, fibers, and other narrow items are not very apparent, but they may cause water leakage. En EN 17 Water Leakage Test The final test after loading the camera is explained below. En 1 Simple water leakage test Place the Case slowly into the water. Explanatory image Hints As the Case is transparent, waterdrops entering into it can be confirmed easily. In case of trouble with the O-ring, three seconds are enough for water to enter. Remove the Case from the water and check that no water has leaked at the inside of the Case. Remove the Case from the water and check that no water has leaked at the inside of the Case. Taking Pictures Under Water Underwater shooting modes kUnderwater Wide-Angle 1 Suitable for shooting a scene that extends across a wide range such as a school of fish swimming through the water. [. . . ] Maintaining the Waterproof Function Whenever you open the rear lid of the Case, always be sure to perform the O-ring maintenance operation as described below. Perform at the location without sand or dust, after washing and drying your hands. En Remove the O-ring 1 Insert the O-ring remover between the O-ring and the O-ring groove. (Be careful not to scratch the O-ring groove with the tip of the O-ring remover. [. . . ]