User manual KAWAI K1R

[. . . ] Shall not be responsible in any way for lost profits or any claims by third parties in case of any damage occurring from improper use of this product. Caused by loss of image data because of defects, disassembly, repair or modification of this product by people other than third parties specified by KAWAI IMAGING CORP. Please read the following items before use This Case is a precision device designed for use at a water depth within 40 m. Please use the Case correctly after sufficient understanding of the contents of this manual in regard to handling of the Case, checks before use, maintenance, and storage after use. [. . . ] When one of the buckles is left open, the Case will not be sealed and water leakage will occur. ⷠClose the rear lid of the Case so that the LCD hood and the lens cap strap don't catch. 1 Push the POWER button on the Case and confirm that the camera turns ON/OFF. 3 Press the shutter lever on the Case and confirm that the camera shutter releases. ⷠAlso operate other control buttons on the Case and confirm that the camera functions properly. EN 19 CAUTION: If the camera does not function properly, reinstall the digital camera following the procedures of "Check the digital camera. When using the Case, the current camera shooting scene and shooting mode can be confirmed on the camera's LCD monitor. Installation Strongly push the mounting projections of the LCD hood as shown in the figure into the guides above and below the LCD monitor window. En Removal Remove the mounting projections of the LCD hood from the guides above and below the LCD monitor window by widening the LCD hood. Visual Inspection After sealing the Case, check the sealing part of front and rear lid visually to confirm that the O-ring is not twisted or out of the groove and that no foreign matter has been caught. CAUTION: Hairs, fibers, and other narrow items are not very apparent, but they may cause entry of water. Mode dial knob En Select the scene OK button Locking AF during underwater shooting When Underwater Wide-Angle 1 or Underwater Macro is selected, the down arrow pad on the case functions as the AFL button. With focus locked, you can concentrate on operating the shutter whenever a perfect picture opportunity arises. note: · To cancel the AF lock status, press the down arrow pad (AFL button) again. ⷠYou can select the underwater movie mode for µ 1030 SW/Stylus 1030 SW. ⷠPress the MENU button and press the up/down arrow pad to select MOVIE, then press the OK button. Press the up/down arrow pad to select UNDERWATER MOVIE, then press the OK button. Functions as the AF LOCK button in the Underwater Wide-Angle 1 and Underwater Macro modes. En After completing the shooting and returning to land, wipe off any waterdrop sticking to the Case. Use air or a soft cloth not leaving any fibers to thoroughly wipe any waterdrop etc. From the joint between the front and rear lid, the shutter lever, the palm grips, and the open/close dial. cAUTION: · When waterdrops remain between the front and the rear lid, they may spill to the inside when the Case is opened. [. . . ] En Q6: A6: EN 35 Q7: A7: En How can I check for water leakage?For confirmation, perform the advance test and the final test after loading the camera. The advance test with immersing the Case without the camera to the intended use depth to check for water leakage is the most accurate test, but when this is difficult, it is safer to perform this test even at a depth of 1 m or in a bathtub. 3 Damage, deterioration or deformation of the O-ring 4 Sand, fibers, hair or other foreign matter on the O-ring 5 Sand, fibers, hair or other foreign matter on the O-ring groove or the O-ring contact surface 6 Catching of the strap, the bag of silica gel, etc. [. . . ]