User manual KAWAI K1II WAVE LIST

[. . . ] In this manual, µ 1020/Stylus 1020 is used for all the camera illustrations. Introduction Unauthorized copying of this manual in part or in full, except for private use, is prohibited. Shall not be responsible in any way for lost profits or any claims by third parties in case of any damage occurring from improper use of this product. Caused by loss of image data because of defects, disassembly, repair or modification of this product by people other than third parties specified by KAWAI IMAGING CORP. [. . . ] Is there any dirt or foreign matter on the O-ring or the O-ring contact surface on the front lid?Close the rear lid gently (so that the O-ring does not slip out of the groove), hook the buckle on the edge of the rear lid, and tilt the buckle lock/unlock lever in the direction of the arrow to seal the Case hermetically. en CAUTION: · Seal the Case by turning both buckle lock levers down in arrow direction. When one of the buckles is left open, the Case will not be sealed and water leakage will occur. Close the rear lid of the Case so that the LCD hood and the lens cap strap don't catch. 1 Push the POWER button on the Case and confirm that the camera turns ON/OFF. 3 Press the shutter lever on the Case and confirm that the camera shutter releases. Also operate other control buttons on the Case and confirm that the camera functions properly. EN 19 En CAUTION: If the camera does not function properly, reinstall the digital camera following the procedures of "Check the digital camera. When using the Case, the current camera shooting scene and shooting mode can be confirmed on the camera's LCD monitor. Installation Strongly push the mounting projections of the LCD hood as shown in the figure into the guides above and below the LCD monitor window. When the focus is locked, the AF lock indicator (AFL) appears on the top right of the LCD monitor screen of the camera. To switch to a different underwater shooting mode, press the MENU button on the Case, press the down arrow pad, select SCN on the LCD monitor, and press the OK button. Then press the arrow pad to select the desired underwater shooting mode from the LCD monitor display, and press the OK button to enter the selection. Mode dial knob Select the scene OK button En Locking AF during underwater shooting When Underwater Wide-Angle 1 or Underwater Macro is selected, the down arrow pad (AFL button) on the case functions as the AF LOCK button. With focus locked, you can concentrate on operating the shutter whenever a perfect picture opportunity arises. Note: To cancel the AF lock status, press the down arrow pad (AFL button) again. Functions as the AF LOCK button in the Underwater Wide-Angle 1 and Underwater Macro modes. En After completing the shooting and returning to land, wipe off any waterdrop sticking to the Case. Use air or a soft cloth not leaving any fibers to thoroughly wipe any waterdrop etc. From the joint between the front and rear lid, the shutter lever, the palm grips, and the buckle. cAUTION: · When waterdrops remain between the front and the rear lid, they may spill to the inside when the Case is opened. [. . . ] In order to avoid losing shutter chances due to an exhausted battery, you should always replace a battery with a fully charged battery before each dive. En Q6: A6: EN 35 Q7: A7: En How can I check for water leakage?For confirmation, perform the advance test and the final test after loading the camera. The advance test with immersing the Case without the camera to the intended use depth to check for water leakage is the most accurate test, but when this is difficult, it is safer to perform this test even at a depth of 1 m or in a bathtub. [. . . ]