User manual KAWAI K11

[. . . ] WARNING This product should be kept out of reach of infants and children to prevent accidents such as the following: · Injury caused by the product falling from a height and striking the body from a height. If it is broken or smashed by being dropped or hit against a hard object, glass splinters could cause injury. If water gets into this product during underwater use, immediately stop using it, remove the moisture from the product and detach it from the camera and lens. When mounting this product on the PT-E series underwater case or the PER-E02 Underwater Extension Ring, be sure to follow the instructions in this manual. [. . . ] After this, apply thin layers of the provided silicone Oring grease on these parts. Align the threaded section of the PER-E02 extension ring with the port mount thread on the PT-E series case. Resistance increases as the PER-E02 extension ring is screwed in more deeply. However, be sure to screw it in all the way until there is no gap visible between the case's port mount thread and the extension ring's threaded section. If the resistance is extremely high, apply some more silicone O-ring grease again to surfaces listed above. Align the lens port mount thread of the PER-E02 extension ring with the threaded section on the K11. However, be sure to screw it in all the way until there is no gap visible between the K11's thread section and the extension ring's port mount thread. If the resistance is extremely high, apply some more silicone O-ring grease again to surfaces listed above. E-3 3 Attaching/Removing the Front Cap To attach the front cap, fit it into the front end (lens hood) of the K11 as shown below. CAUTION: 4 Adjusting the Lens Hood Position If the corners of the image in the pickup finder are cut off after the K11 is attached, adjust the lens hood position. Using the clamping screw securing wrench provided with the K11, loosen the four lens hood clamping screws on the K11. Zoom gear Confirm that the position alignment mark on the zoom gear is aligned correctly with the index on the lens and that the zoom gear is attached properly. CAUTION: If the zoom gear position is not aligned correctly, smooth zooming control is not possible. 2) When using the ZUIKO DIGITAL ED 8mm Fisheye lens To enable manual focusing of this lens, we are developing a separately available MF gear (to be released in early 2006) for attachment to the lens's MF ring. E-7 7 Loading the Camera and Lens The following description is applicable when the ZUIKO DIGITAL ED 7-14mm lens is used. Screw the camera table provided with the PT-E series case firmly into the bottom of the camera. If a lens cap or filter is attached to the lens or the strap is attached to the camera, remove them as well. mode dial knob Zoom dial Power switch dial Pull out the zoom dial further. MENU Camera table lock lever Lift the PT- E series case's power switch dial, mode dial knob and zoom dial, and turn the case's camera table lock lever counterclockwise to release the lock. mode dial knob Zoom dial Power switch dial Pull out the zoom dial further. Then, push in the zoom dial on the case and engage it with the zoom gear attached to the lens. Push in the PT- E series case's power switch dial and mode dial knob. [. . . ] Also remove any foreign matter from the O-ring contact surfaces and from the port mount thread on the PT-E series case. After removing foreign matter, apply the provided grease to the O-rings and fit them into the O-ring grooves. To apply grease to each O-ring, squeeze a drop of grease about the size of a grain onto your finger and lightly rub the entire circumference of the O-ring to spread the grease thinly and evenly. 935 g Applicable case Applicable lens Main materials Main body Lens O-rings Front cap Rear cap Withstanding pressure Dimensions Weight Note) We reserve the right to change the external appearance and specifications without notice. [. . . ]