User manual KAWAI FS780

[. . . ] shall not be responsible in any way for lost profits or any claims by third parties in case of any damage occurring from improper use of this product. caused by loss of image data because of defects, disassembly, repair or modification of this product by people other than third parties specified by KAWAI IMAGING CORP. or for other reasons. Please read the following items before use This Case is a precision device designed for use at a water depth within 40 m. Please use the Case correctly after sufficient understanding of the contents of this manual in regard to handling of the Case, checks before use, maintenance, and storage after use. [. . . ] CAUTION: · The most suitable method for checking water leakage is to immerse the Case to the intended water depth. When this is difficult, water leakage also can be checked at a shallow depth with no water pressure. · If the advance test should show water leakage with normal handling, stop using the Case and contact your dealer or an Olympus service station. En EN 15 3. Installing the digital camera Check the digital camera Check the digital camera before loading it in the Case. Battery Confirmation Underwater shooting can reduce battery life because the picture has to be checked on the LCD monitor before and after shooting. Make sure that you have sufficient remaining battery capacity before use. CAUTION: In order to avoid missing photo opportunities due to an exhausted battery, you should always have a fully charged battery before each dive. Check the remaining number of pictures Check that the image storage medium has enough room for the number of pictures you want to take. Remove the strap and lens cap from the camera. Be sure that the strap, and/or lens cap are not attached to the digital camera. CAUTION: · If the digital camera is loaded without removing the strap and lens cap, the Case cannot be sealed properly and may leak. · Handle the digital camera carefully when removing the strap and lens cap. Olympus does not assume any liability for damage incurred if the camera is dropped. Remove the eyecup from the digital camera. The Case allows you compose your shots in the pickup viewfinder or the LCD monitor. To improve the view of the pickup viewfinder, remove the camera's eyecup before loading it in the Case. For details, see "How to attach the camera table to the digital camera" (P. Otherwise, if the automatic pop-up setting of the camera is ON and the camera is set to a scene mode other than the AUTO or underwater modes, turning the camera ON before turning the electronic flash on would cause the camera's built-in flash to pop up automatically. Always be sure to turn the electronic flash ON before turning the camera ON. 4 Load the camera in the Case, and then connect the hot shoe cable to the camera. En CAUTION: · For details on camera function setup, refer to the camera's instruction manual. · If the camera's built-in flash pops up while the hot shoe cable is connected to the camera, it will interfere with the hot shoe cable, either disconnecting it or causing a connection failure. · When using a slave-type underwater flash from a non-Olympus manufacturer, pop the camera's built-in flash up before loading it in the Case. · Once the camera has been loaded in the Case and the Case has been sealed by closing the slide lock and open/close dial it is no longer possible to pop up or retract the camera's built-in flash. · When using an optional electronic flash with underwater case, a bracket is required to attach the electronic flash case to this Case. EN 20 Insert the digital camera in the Case Load the digital camera in the Case after checking the following: · Is the digital camera turned OFF?· Is camera media (either xD-Picture Card or CompactFlash) loaded into the camera?· The strap, lens cap and filter are removed from the digital camera. · The camera table provided with the Case is attached to the tripod screw hole at the bottom of the digital camera. · The camera's eyecup is removed from the camera's viewfinder. [. . . ] · Do not use a volatile solvent such as alcohol, lacquer thinner or benzine or a chemical detergent to clean the Case. Metallic parts should be immersed in fresh water and washed thoroughly after use. If you are concerned with the possibility of rust, apply a thin layer of the silicone grease to the metallic parts before use. Please contact a service station of our company or your dealer, if repair should be necessary. [. . . ]