User manual JWIN JX-CD935

[. . . ] Please remove batteries from the battery compartment if you are not going to use the unit for long time. Charging Circuit This unit is equipped with a built-in charging circuit. Si t C a i s ih ni t C cm a m nt t " N psi l eh hr n wt i d h D o pr eto h O " oio de g g c se e t e tn 2. Insert the Rechargeable batteries (Ni-Cd or Ni-Mh 650mAh, not supplied) into the btr cm a m n acri tt " ae Is lt n d et n aoe ae o pr etcod go h B tr ntli " i cos bv. [. . . ] Connect the DC socket of the AC Adaptor (not supplied) into the DC jack of the unit as mentioned above. The rechargeable batteries should be recharged before they are used for the first time or if they have not been used for a long period of time (over 60 days). Please make sure to unplug the AC adaptor and slide the charging switch to the " F " oio a e1 hus fhri . O F psi f r 5 oro ca n tn t gg Note: Please make sure that only Nickel-Cadmium or Ni-Mh batteries are used for re-charging. Do not attempt to charge any regular kinds of non-rechargeable batteries. Performance of rechargeable batteries will deteriorate as a result of regular depreciation. Purchase a new set of batteries when the operating time decreases drastically, even when the rechargeable batteries are properly recharged. Listening with Headphones Connect the plug of the stereo headphones into the headphone jack (marked phones). Warning: Before listening from the Headphones, please make sure that you have set the volume output to a reasonable level. Listening at excessive volume levels can damage your ears and result in a hearing loss. Press the PREV/NEXT buttons ( or ) to select the track to be programmed. The programming will be cancelled when the CD door is opened or the unit is turned OFF. REPEAT Repeat 1 During CD play, pressing the CD MODE button once will enable the unit to play the current track repeatedly until the STOP button is pressed. The symbol wlapai t d p y ui " eet " oe i pernh i l dr g R pa1 m d. l e sa n Repeat All During CD repeat play mode, pressing the CD mode again will enable the unit to play the whole disc repeatedly until the STOP button is pressed. During CD play or CD Stop condition, press the CD MODE button three times. r sh P A / U Ebt n h " R "n c o n h C i i t p Pe t L YP S u o N dar e lg se A t and the first 10 seconds of each song will be played until the STOP button is pressed. Press the MODE button four times and then the PLAY/PAUSE button during CD Play or Stop mode to enable the unit to play the tracks from the Disc randomly. Press the NEXT () button to skip to the next randomly selected track; 3. To avoid accidental operation of the unit and consume batteries, slide the " O D s iht t r h T i wll ka t C ky adpee H L " wt o h i t h i o l h D es n r nt c e g. Whn h uiiudr H L " od i ad h Pa/as bt nibi e t n s ne " O D cnio n t l Pue u o s e g et tn ey t n pesd" O D wlf s o t L D r e, H L " i l h n h C . [. . . ] To avoid accidental operation of the unit and consume batteries, slide the " O D s iht t r h T i wll ka t C ky adpee H L " wt o h i t h i o l h D es n r nt c e g. Whn h uiiudr H L " od i ad h Pa/as bt nibi e t n s ne " O D cnio n t l Pue u o s e g et tn ey t n pesd" O D wlf s o t L D r e, H L " i l h n h C . Si n t " O D s iht t l t i eal a t CD keys to operate l i h H L " wt o h e wl nb l h dg e c ef l ele normally. ANTI-SHOCK BUTTON (ESP) * Press the ANTI-SHOCK button to switch the ESP function on or off. i lg e Maintenance Cleaning the lens A dirty lens will cause sound skipping or poor performance. [. . . ]