User manual JWIN JX-CD488

[. . . ] DANGER: INVISIBLE LASER RADIATION WHEN OPEN AND INTERLOCK FAILED OR DEFEATED. CAUTION: HAZARDOUS LASER RADIATION WHEN OPEN AND INTERLOCK DEFEATED. CLASS 1 LASER PRODUCT LUOKAN 1 LASERLAITE KLASS 1 LASERAPPARAT 1. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or grounding type plug. [. . . ] PLAY / PAUSE : playback from the built-in compact disc player TUNER / BAND: radio, selection of the frequency bands Adjusting the volume To adjust the volume, press the "VOLUME UP/ DOWN" button (4)/(40)/(42). AM/FM radio operation Switch the unit on by pressing the "POWER" button (1)/(32). Switch to the Tuner operating mode by pressing the button "TUNER / BAND" (7)/(53). About the tuner's preset station memories Each time the "MEM. /CLK ADJ. " button (9)/(50) is pressed, the memory positions are called up one after another in ascending number order. The memory positions are selected directly using the numerical keys "1 - 0 / +10" (33) on the remote control. Program sites 10 - 19; Press button "+10" and then the appropriate button " 0 - 9". Program site 20; Press button "+10" twice and then the button "0". Programming AM and FM Stations in Memory The program memory allows you store 30 stations in FM and AM range. Program place selection is described in the previous operating section. Seek out the station required by "Manual station selection" or "Station search operation". Press the "MEM. /CLK ADJ. " (9)/(50) and then Note: You can also directly select the desired program preset by pressing numeric buttons "1-0 / +10" (33) on the remote control. Changing a program position If a memory position needs to be replaced by a station other than the current one, the new station can be programmed as described above, and will replace the original station. Manual station selection Press button "TUNER / BAND" (7)/(53) repeatedly until the desired frequency band appears. Make sure the tuner is tuned to a radio station, or for CD operation, a CD must be inserted. Snooze function: When the unit is switched on by means of the timer, you can press the SNOOZE button (23)/(37) to switch the unit off for approximately 9 minutes. Setting the sleep timer: When the unit is in operation it can be set to automatically switch-off 10 to 120 minutes later. Press SLEEP (25)/(52), as required, until the desired delay time appears on the display. The SLEEP timer can be set for: 120, 90, 60, 50, 40, 30, 20, and 10 minute intervals. The unit automatically turns off after the entered time has elapsed. (TOC means Table of Contents) If there is no CD inside, the following will appear after a few seconds: If the playback of one CD has finished, the playback of the next inserted CD begins, and so on. Note: If the CD player is in stop position, you can start the currently indicated CD by pressing the button " PLAY / PAUSE" (13)/(38). If you select a different CD by pressing the buttons "CD SELECTION 1 - 4" (5) or "DISC 1 - 4" (49), playback will start automatically. Pause / stop Inserting and ejecting the CD The CD compartment (2)/(26) is opened for inserting or removing compact discs by pressing the "OPEN / CLOSE" (15) or (16) button. To briefly interrupt playback, press " PLAY / PAUSE" button (13)/(38). The display indicates: 11 Insert the disc with the unlabelled side facing the unit. Press the centre of the CD onto the black holder that is fitted with 3 retaining bearings. [. . . ] The tracks can be selected directly by pressing the corresponding numerical buttons 1 - 0 / +10. Insert the MP3 disc with the unlabelled side facing the unit. Press the center of the CD onto the black holder fitted with 3 retaining bearings. To remove the CD, hold it by the edges and remove it by gently pressing on the black holder. Then close the disc compartment by pressing the "OPEN / CLOSE" button (15) or (16). [. . . ]