User manual JWIN JX-CD280 Instruction Manual

[. . . ] When charging for the first time or after a long time, playing time may be reduced. In this case, charge and discharge the batteries several times. NOTE ON ALKALINE BATTERIES 1. When replacing the alkaline batteries, use two new batteries of the same type. Do not mix a used battery with a new one or mix different types of batteries. [. . . ] We want you listening for a life time. PLAYING A DISC Be sure to reduce the volume before plugging in or unplugging the headphones/ earphones 1. Hold the disc with the label side up and press it onto the spindle until it "clicks" into place. Close the disc compartment, press PLAY/PAUSE button, the disc will begin to spin, the display will indicate "01", play will begin immediately from track number 1. To stop play, press the Stop Button, and the power turns off automatically after a while. Place only one disc at a time in the CD compartment. TRACK SEARCH · · · · Press the Press the Press the Press the and button during play to skip to the desired track. twice or more to skip to previous tracks. FORWARD/REVERSE SEARCH Press and hold the skip ( ) button during play to scan the disc at high speed. ----forward ----reverse ) while playing, it will scan the current · If you press and hold the skip button ( playing track forward at high speed. ) while playing, it will scan the current · If you press and hold the skip button ( playing track backwards at high speed. 3 BASS BOOST Use the Bass Boost function to increase the bass output when listening with headphones. During bass boost on setting, sometimes, you may hear some distortion, adjust the volume control to a lower level when using the bass boost feature. ON OFF BASS BOOST PROGRAMMED PLAY The tracks on the disc can be programmed for play in any order. (Up to 24 tracks can be programmed. ) During programming, "PROG" flashes in the display. Press the skip button ( Press the PROGRAM button again to enter the track into the memory. Note: Programmed play will begins automatically if you program 24 tracks. "PROG" shows steady in the display and programmed play begins. The player stops automatically after all programmed tracks have been played. To check the program, press the STOP Button and then the PROGRAM button. THE CD MODE BUTTON This button can be pressed during play to accomplish many different kinds of play. 5 times for return to normal play. SINGLE TRACK REPEAT Press the CD Mode button once during play, and the " 1" will appear in the display. The current track will be played over and over again until Stop button is pressed. ALL TRACKS REPEAT/CONTINUOUS PLAY Press the CD Mode button twice during play. The all tracks on disc will be played over and over again until Stop button is pressed. INTRO PLAY Plays the first 10 seconds of all tracks once, then stops. [. . . ] Do not expose discs to direct sunlight, high humidity, or high temperatures for extended periods. Sharp writing instruments, or the inks used in some felt-tip pens, may damage the surfaces of the disc. Always place the compact disc to be played in the CD compartment with the label facing upward. Fingerprints should be wiped from the surface of the disc with a soft cloth. [. . . ]