User manual JWIN JT-P850

[. . . ] 2. 2. 2 Battery Low Detection and Indication If the battery is not installed in the battery compartment or the battery has been used for a long time, the LED "Lo" flashes on to alert the user to replace the battery. If a new battery is not installed, the messages may be lost once power interruption occurs. The user has to record the OGM again or the machine will answer call then play the default OGM. [. . . ] 7 Playing new ICM Messages Procedure of playing new messages is as follows: - If new message(s) has/have been recorded, the ANSWER ON/ OFF LED will keep flashing. - Press the " PLAY/STOP " key, the new messages will be sequentially played - If DTS has been set, the total number of messages DTS is first played. - The ANSWER ON/ OFF LED will stop flashing but will be turned on after all new messages have been played to indicate the absence of new messages. Recording a Memo Memo is a message left for others who directly access to the answering machine. - Press and hold the " MEMO/repeat " key for about 2 seconds. The display will count up from "0" to show the duration of the recording. - AMSWER ON/OFF LED will flash to indicate the presence of new memo. 2. 2. 8 2. 2. 9 Two-way Conversation Recording - Press and hold the "MEMO/REPEAT" key for about 2 second. - Recording will stop if "STOP" key is pressed, or if silence, busy tone or continuous tone is detected. - The display will blink " oo " and the ANSWER ON/OFF LED will flash to indicate the presence of newly recorded conversation. 10 Play Memos - If new memos and /or conversation are recorded, the display will blink "oo" - Press the " MEMO/REPEAT2WAY " key once, only the MEMOS and/ or two-way conversation will be sequentially played. The display will stop blinking "oo" after all memos or conversations have been played. However, the user may press "PLAY/STOP" key to play all kinds of messages. - The other procedure is similar to "Play all message" step. However, if the user just presses "MEMO/REPEAT" key to play back messages, that LED will keep flashing after the end of playback PAGE 4 2. 2. 11 Erase and Save all messages - Press the " ERASE " key for about 2 seconds, all the messages will be erased after hearing a long beep if the messages exits, or an alarm two-beep if no message exists. - Press the " ERASE " key for about 2 seconds after all messages are been erased; the erased messages will be saved after hearing a long beep. [. . . ] - When there is an incoming call ANS/OGM LED will flash in the cadences of the ring. 2. 2. 18 Call Screening When a call is received in DAM ON State, the machine will play OGM. The machine will monitor the pick-up of parallel phone after it has seized line for 2 seconds. [. . . ]