User manual JWIN JL-CD808

[. . . ] For MW reception the signals are picked up through the built-in ferrite antenna. Press the STANDBY/ON button to turn the unit on, the STANDBY/ON LED indicator will light. Silde the FUNCTION switch to the desired band (AM or FM) and tune a station by turning the TUNING control. [. . . ] To check, open the disc compartment again and reload the disc. DISC PLAY m m m m Insert a CD as described in the previous section and close the disc compartment. To skip forward or backward through the tracks on the disc, press the SKIP forward / backward buttons. Press STOP button to stop disc before it is finished. Notes: - If the disc is deeply scratched, or too dirty, disc play may not start. If an improperly centred disc is played, noise can be heard in the mechanism. - If the disc is inserted incorrectly, or the disc is damaged the display will show ]No disc^. 4 DISC ERRORS This compact disc player has built-in error compensation circuits to correct for minor defects in a disc. In some cases, the CD player may skip some tracks, or parts of tracks, on a disc during disc play. This problem may be caused by defects (such as scratches) in the disc being played, which are too large for the error compensation circuits to handle. If you encounter this problem, check the CD player's operation as follows, before having the unit serviced: Play a new disc. If the CD player operates normally, the skipping problem is probably due to a defective disc. Disc play will stop and the display will show the total number of tracks To temporarily stop disc play (pause mode), press the Play/Pause button. To resume disc play, press the PLAY/PAUSE button again. REPEAT DISC PLAY Use the REPEAT button to listen to an entire disc, one track repetitively. FOR REPEAT PLAY OF O N E OF THE TRACKS m m m m m FOR With a CD inserted, silide the FUNCTION switch to the CD position. Press the Play/Pause button and the unit will then play the same track over and over until the STOP button is pressed. If the REPEAT button is pressed 2 more times during play, the REPEAT indicator will go off, Repeat Mode will end and normal playback will resume from that point. [. . . ] When the actual time matchs one of the selected preset alarm times, the buzzer will sound for 60 minutes and then shuts off. THE TO SET m m m ALARM TO WAKE TO RADIO Set the alarm time as previously instructed. When the actual time matches one of the selected preset alarm times, the unit automatically turns on for 60 minutes and then shuts off. THE TO SET m m m ALARM TO WAKE TO CD Set the alarm time as previously instructed. When the actual time matches one of the selected preset alarm times, the unit automatically turns on for 60 minutes and then shuts off. Note: TO SHUT m THE - When the disc is through playing it will stop. ALARM OFF To shut the alarm off, press the STANBY/ON button once and the alarm time will be reset for the next day. [. . . ]