User manual JWIN JL-304

[. . . ] DISPLAY BUTTON (Set the Clock) Selects radio frequency or clock display. To set the clock: 1. With clock display selected, hold down the (CLK) button until clock display starts flashing. PRESET STATIONS Six numbered preset button store and recall stations for each band. Storing station 1. Select a band (if needed) 2. Select a station 3. Hold a preset button longer than one second. Preset station number appears in the display when station is saved. [. . . ] Recall a station: 1. Select band (if needed) 2. Press a preset button for less than one second to select stored station. AUTOMATICALLY STORE STATIONS Select six strong stations and store them in current band. 1. Select a band (if needed) 2. Hold A/PS button for more than three seconds. The new station replace stations already stored in that band. Preset A/PS 1. Select a band (if needed) 2. Touch A/PS for more than one second but less than three seconds. Radio pauses for five seconds at each station. Touch A/PS again to stop scanning when the desired station is reached. 12. STEREO/MONO SELECTOR This function will only affect FM reception. Press this button if the FM reception becomes noisy/hissy. If the station being received is in stereo, it will now be played in mono. Press this button again to return tthe receiver to normal reception 13. MODE BUTTON (MODE) By pressing this key, user can select RADIO mode, AUX mode, CD PLAYER mode. 14. MUTE BUTTON Press the MUTE button to stop and the lcd will flashing indication "MUTE". SCAN BUTTON Press this button briefly (LESS THAN 2 SEC. )and the radio will tune to the next memory preset station, pausing for 6 seconds, and repeating the process endlessly until a selection is made. To stop scanning, press this button briefly once again, or press the preset button that Corresponds to the channel number blinking on display. 16. PANEL RELEASE BUTTON Press the button and the right-side section of the panel will release. 2) menu2:BEEP ON--BEEP OFF The situation of beep sound is selected. The 2 mode is selected as also vol up or vol dn key. Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system work properly. Use only the parts included with the unit to ensure proper installation. Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle. Install the unit where it does not get in the driver s way and cannot injure the passenger if there is a sudden stop. If installation angle exceeds 30 from horizontal the unit might not give optimum performance. Avoid installating the unit where it would be subject to high temperature. such as from direct sunlight. Lower case or from hot air, from the heater, or where it would be subect to dust, . dirt or excessive vibration. HOW TO REMOVE AND INSTALL THE FRONT PANEL 1. To install the front panel, insert the panel into the housing and make sure the panel is securely installed, otherwise, abnormalities occurs on the display or some keys will not function properly. DIN FRONT/REAR-MOUNT This unit be can properly installed either from Front (conventional DIN Front-mount) or Rear (DIN Rear-mount installation, utilizing threaded screw holes at the sides of the unit chassis). -- 4 --- 5 -- DIN FRONT- MOUNT (Method A) Installing the unit USING THE RESET BUTTON 1. Holder After inserting the holder into the dashboard, select the appropriate tab according to the thickness of the dashboard material and bend them inwards to secure the holder in place. [. . . ] Holder After inserting the holder into the dashboard, select the appropriate tab according to the thickness of the dashboard material and bend them inwards to secure the holder in place. Screw Press button with a thin, pointed object if unit is malfonctioning. Though not a normal occurrence, the microprocessor which controls the operation of this unit can be affected by electrostatic noise. This generally is indicated by such symptoms as no power being supplied when you switch the unit on, failure of buttons and controls, or an abnormal display. [. . . ]